Floe Cargo Max 9.5-73, Cargo Max 11-73, Cargo Max 13-73 Assembly Instructions Manual

650-72000-00 All material copyright ©2017 FLOE International, Inc. Unauthorized reproduction is strictly Prohibited. Specifications subject to change without notice. 8/7/17

1

Cargo Max Assembly Instructions

9.5-73
11-73
13-73

TOOLS REQUIRED

1. ¾” Socket / Wrench (2) 5. ½ Drive Extension

2. 7/8” Wrench (Tongue Nut) 6. Torque Wrench

3. 13/16” ½ Deep Socket (Lug Nuts) 7. Cordless Drill

4. #2 Phillips Bit (License Plate Bracket)

650-72000-00 All material copyright ©2017 FLOE International, Inc. Unauthorized reproduction is strictly Prohibited. Specifications subject to change without notice. 8/7/17

2

Cargo Max Assembly Components

Sub-assembly
Components

1. Bed & Frame

(Wired w/ side, clearance, tail
lights) ASSEMBLED

2. Axle, Hubs, Tires ASSEMBLED

3. Tailgate Ramp ASSEMBLED

4. Tongue & Tongue Jack ASSEMBLED

5. Wheels & Tires ASSEMBLED

650-72000-00 All material copyright ©2017 FLOE International, Inc. Unauthorized reproduction is strictly Prohibited. Specifications subject to change without notice. 8/7/17

3

Cargo Max Assembly – Step 1

ATTACHING THE AXLE

Fig. 1A

1. Locate the axle isolation strips packed in the

assembly components kit.

2. Place an isolation strip on the two inside

surfaces of the axle mount as shown in Fig.
1A.

3. Place the trailer frame on the axle mounts,

aligning the holes in the axle mount with
the front two holes in the frame. Note the
orientation of the torsion arms in Fig. 1B.

4. Insert (2) ½-13 x 3-1/4” bolts through the

two washers and through the bottom holes
on the axle beam brackets as shown in
Fig.1B.

5. Fasten with (2) flat washers and (2) nylock

nuts. Make sure that the axle mount and
axle beam are tight together with no gap
before tightening. Torque to 40 FT/LBS.