Flexston MaxiFlex 300, MaxiFlex 3000 Quick Manual

Quick Guide V1.0

Battery Bank for Flexston

MaxiFlex 3000

1. Important Safety Warnings

Please comply with all warnings and operating instructions in this manual
strictly. Save this manual properly and read carefully the following instructions
before installing the unit. Do not operate this unit before reading through all
safety information and operating instructions carefully.
 Do not try to repair the unit yourself, contact your local supplier or your

warranty will be void.

 To eliminate any overheating of the battery box, keep all ventilation vents

free from obstruction and do not place any for eign objects on top of the
battery bank. Keep the battery box 20 cm away from the wall.

 Make sure the battery box is installed within the proper environment as

specified. (0-40°C and 30-90% non-condensing humidity)

 Do not install the battery box under direct sunlight. Your w arranty will be

void if the batteries fail due to overheating.

 This battery box is not designed for use in dusty, corrosive and salty

environment.

 The warranty for this battery bank will be void if water or other liquid is

spilt or poured directly onto the battery box. Similarly we do not warrant

any damage to the battery box if foreign objects are deliber ately or
accidentally inserted into the battery box enclosure.

 The battery will discharge naturally if the system is unused for a period of

time.

 It should be recharged every 2-3 months if unused. If this is not done,

then the warranty will be null and void. During normal operation, the
batteries will be automatically remained in charged condition.

 Servicing of batteries should be performed or supervised by qualified

personnel and with required precautions.

 When replacing batteries, it is necessary to replace ALL batteries with the

same quantity, type & capacity.

 CAUTION – Do not dispose of batteries into a fire. The battery may

explode.

 CAUTION – Do not open or damage the batteries. The electrolyte from

the batteries is toxic and harmful to the skin and eyes.

 CAUTION – Risk of Electric Shock –Hazardous voltage may exist between

battery terminals and ground. Test before touching with bare hands.

 CAUTION – A battery can present a risk of electrical shock and short

circuit current. The following precaution should be observed when
working on batteries:

1. Remove watches, rings, or other metal objects.

2. Use tools with insulated handles.

3. Wear rubber gloves and boots.

4. Do not lay tools or metal parts on top of batteries.

5. Disconnect mains prior to connecting or disconnecting battery
terminals.

 Do not plug or unplug the battery connector if UPS works in DC

(discharging) mode.

2. Installation and Setup

NOTE: Before installation, please inspec t the unit. Be sure that nothing inside

the package is damaged. Please keep the original package in a safe place for
future use.

2-1 Rear Panel View

1. DC connector : connects to either UPS or 2

nd

battery box

2. DC breaker: Battery over-current protection breaker