Flex TPO Plus T-joint Cove User Manual

Product Data Sheet
FLEX TPO PLUS T-JOINT COVER
Flex TPO Plus T-Joint Covers are used to seal step-offs at splice intersections. Installation is mandatory on all 60 mil and thicker TPO membrane systems and on 45 mil systems where step-offs have not been properly sealed. Flex TPO T-Joint Covers are made from 60 mil non-reinforced flashing cut into a 4.5 diameter circle. Packaged in a box containing 100 covers. Available in white, tan and gray.
PHYSICAL PROPERTIES
Size: 4.5 (114 mm) Thickness: 0.060 (1.5 mm) Packaging: 100 per box Weight (per box): 3.5 lbs. (1.6 kg) Material: Non-reinforced TPO Flashing Color: White, Gray or Tan
INSTALLATION
1. Clean splice intersection area with Flex Weathered Membrane Cleaner.
2. Use a lower temperature setting on the heat welder than compared to welding reinforced
membrane. (Typically a setting of 6 on a scale of 10 is appropriate for welding TPO T- Joint Covers.)
3. Center the Flex TPO T-Joint Cover over the splice intersection. Begin welding at the center point and work towards the outside. Use the edge of the roller to crease the T-Joint Cover into membrane step-offs to achieve a proper seal.
4. Using a probe, check all splices for voids and cold-welds. Make any needed repairs.
CAUTIONS AND WARNINGS
· The Flex TPO T-Joint Cover is not intended for use to overlay fasteners and plates as this requires the use of reinforced membrane.
· Store Flex TPO T-Joint Covers in a cool, shaded area and cover with light-colored, breathable, waterproof tarpaulins. T-Joint Covers that have been exposed to the weather for 7 days or longer prior to use must be prepared with Flex Weathered Membrane Cleaner before hot air welding.
_____________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leisczs Bridge Road, Suite 400, Leesport, PA 19533
Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com
Loading...