Fleetwood LT-2, 0 SUPER GOURMET Instruction Manual

Office

Phone: [phone]

Fax: [phone]

Warehouse

Phone: [phone]

Fax: [phone]

www.skyfood.us [e-mail] -

TOLL FREE 1-800-503-7534

Professional Blender/ Licuador Profesional

Model / Modelos

LT-2,0 SUPER GOURMET

Instructions Manual / Manual de Instrucciones

UG0103 - AUGUST /2011

SUMMARY / INDICE

1. ENGLISH 01

2. ESPAÑOL 09

LT-2,0 SUPER GOURMET

SUMMARY

1. INTRODUCTION ……………………………………………….........02

1.1 Safety ………………………………………………………….....…...02

1.2 Technical Characteristics ……………………………….....………..03

1.3 Main Components …………………………………….....………….03

2. INSTALLATION and PRE OPERATION …………………….........04

2.1 Installation ……………………………………………………...….....04

2.2 ……………......04

3. OPERATION ……………………………………………………........05

3.1 Starting …………………………………………………………….....05

3.2 Feeding Procedures ………………………………………………...05

3.3 Cleaning ………………………………………………………….......05

4 GENERAL SAFETY RULES …………………………………….......06

4.1 Operation Fundamentals Practices ………………………………..06

4.2 Cares and Observations Before to Switch On the Machine …….07

4.3 Routine Inspection ………………………………………………......07

4.4 Operation ………………………………………………………….....08

4.5 After the Work Ends …………………………………………….......08

4.6 Maintenance ......................………………………………………...08

4.7 Advices …………………………………………………………….....08

5 PROBLEMS ANALYSIS and SOLUTIONS …………………........09

5.1 Problems, Causes and Solutions ………………………………….09

What to do or not with your Professional blender

01

02

1. INTRODUCTION

1.1 Safety

When using this equipment, keep in mind some basic safety precautions:

1.1.1 Read all the instructions.

1.1.2 In order to avoid the risk of electric shocks and damage to the machine, never
install equipment on a wet or humid surface nor dip it in water or any other liquid.

1.1.3 The use of the equipment must be supervised when used next to children.

1.1.4 Before cleaning and when not in use or before inserting or removing
accessories, disconnect machine from power source.

1.1.5 Never touch parts of the machine while on movement.

1.1.6 Do not use the equipment if cord or plug is damaged. Do not use the
equipment if it is not working correctly, nor if it has been damaged in any way. In
case that happens, take the equipment to the nearest Technical Assistance to
check it up.

1.1.7 The use of accessories not recommended by the manufacturer may cause
personal hurt.

1.1.8 Keep your hands or any tool out of the machine while operating to avoid
personal hurt or any damage to the equipment. If it is needed to mix etc. switch OFF
and unplug the blender, use only a rubber spatula.

1.1.9 The knives are very sharp. Be careful while handling them.

1.1.10 – Always put the lid on the blender before turning it on.

1.1.11 – Always hold the cup while the blender is working. If the cup gets loose,
immediately turn the machine off.

1.1.12 – Do not use the machine outdoors.

1.1.13 – Do not leave the electric cable on the edge of the table or counter nor
let it touch hot surfaces.

1.1.14 – Do not leave your blender working without supervision.

1.1.15 – Never use water spray directly upon the machine.

1.1.16 – Never turn the machine on with wet clothing or feet.

1.1.17 – Do not operate the equipment with the blade loose, disassembled or
damaged.

Your machine has a thermal relay N°09(Pic.01) that monitors the motor

temperature and automatically turns the motor off in case of overheating.

To restart it, remove the cup from the base and wait until the motor cools
down. After the motor is cool replace the cup and press the button located in the
back of the machine

IMPORTANT

Check your operation if the motor is overheating often..