Page 1
Spray Mate/Spray Master®
Decorative Stainless Steel Insert
Installation Instructions
Installation Sheet #INS-07040
1. Clean top fender channel of dirt and grime.
2. Place the Decorative Stainless Steel Insert in the fender
channel with the
protective plastic PVC
side facing up. Mark
both holes of the insert
on to the plastic fender.
3. Remove the Decorative
Stainless Steel Insert
from the channel and
drill a 3/8” hole on each
mark that was made.
Installation Sheet #INS-07040 • 1/08
4. Place a continuous 1/8”
bead of adhesive in a
zig-zag pattern down
the center of the fender
channel.
5. Place the Decorative
Stainless Steel Insert
into the channel with the
protective plastic PVC
side up.
6. Install a carriage bolt into
each hole of the insert,
place a washer and nut
onto the back side of
each bolt and tighten. Do
not over tighten the bolt
as this will damage the
fender and Decorative
Stainless Steel Inserts.
7. Repeat the procedure
for each of the remaining
Decorative Stainless Steel Inserts.
8. Remove protective plastic PVC from Decorative Stainless
Steel Inserts.
NOTE: These instructions for installation are intended to be a
general guide to help the installer. The installer is responsible for
the ultimate installation design. Any modifications to the product
are at the discretion, responsibility and risk of the installer.
Loading...