Page 1
NOTE: These instructions for mounting back of cab
tire carriers are intended to be a general guide to help
the installer. Because of the large number of possible
mounting configurations, the installer is responsible
for the installation design and for providing adequate
clearance around the tire carrier (i.e. tire clearance,
trailer clearance, etc.)
Back of Cab Tire Carrier
Installation Instructions
Installation Sheet #INS-01018
1. Position the tire carrier on the frame rails behind the truck
cab. Make sure there is adequate clearance for the tire and
handling equipment. Try to keep the tire carrier centered
over the frame rails.
NOTE: Mounting brackets and hardware are not
supplied. Mounting brackets may be fabricated
from suitable size angel or
plate steel.
(1/4” minimum thickness
is recommended) or use
Fleet Engineers’ Universal
Mounting Adapter
(2 required, part
number 033-00374)
This product may not fit all truck models or types of
cabs. Check truck manufacturer for specifications.
Modifications to the carrier may be required. Any
modifications are at the discretion, responsibility and
risk of the installer.
3. Fasten the mounting brackets to the truck frame. Now mark
the mounting brackets position on the tire carrier.
2. Locate the mounting brackets on the frame and tire carrier. Spot any existing holes in the frame on the mounting
bracket. Remove the mounting bracket and drill clearance
holes in it for suitable hardware (minimum of two 1/2” Grade
8 bolts per bracket is recommended) If no existing holes in
the frame are useable, some will have to be drilled.
NOTE: Be sure to follow
truck manufacturers recommended procedures
for drilling any required
holes in frame.
Installation Sheet # INS-01018 • 2001 • Rev. B 12/06
4. Fasten the mounting brackets to the tire carrier by welding or
drilling holes and bolting. (Minimum of two 1/2” Grade 8 Bolts
per bracket is recommended)
5. Torque all bolts to recommended specifications.
NOTE: the tire carrier may be mounted on top of a safety
service deck, but the tire carrier mounting brackets must be
fastened to the truck frame.
Loading...