800 Poertner Drive
Berea, OH 44017
1-800-648-8022
www.flamingriver.com
STEERING BOX CENTERING INSTRUCTIONS – FR1540 MOPAR STEERING BOX
WARRANTY: ONE (1) YEAR FROM DATE OF PURCHASE. REPLACEMENT OR REPAIR OF PRODUCT DEEMED
DEFECTIVE BY THE FACTORY.
WEIGHT: 18 LB
TECHNICAL BULLETIN # 1002
ANY LABOR INCURRED IS SPECIFICALLY EXCLUDED.
IMPORTANT!!! It is critical that the steering box be at the center position BEFORE installation.
Incorrect centering will cause loose steering and premature wear. You should feel the box tighten
when at the center.
1) Place the steering box in a bench vise and be certain the box is held securely.
2) Place a ¾”-36 u-joint on the pinion input shaft
3) Turn the shaft to the right (clockwise) all the way to the right lock.
4) Turn the shaft to the left (counter clockwise) all the way to the left lock. (approx. 4-1/8 turns)
5) Turn the shaft to the right (clockwise) half the number of turns. (approx. 2-1/16 turns) You
6) Align the wide spline on the sector shaft of the box with the center of the sector area of the
P
Pinion Shaft Size
NOTE: All boxes are pre-lubricated and pre-adjusted to factory specifications.
16:1 RATIO GEAR BOX FR1540
should feel the box tighten when at the center.
casting.
Pinion Shaft Size:
5/8”-36
Pitman Shaft Thread:
7/8”-14
Because of their intended usage, the manufacturer
makes no warranties whatsoever expressed or implied,
oral or written, to purchasers of their products regarding
performance, safety, fit, merchantability or length of
service. Purchasers are responsible for selection of
proper goods and must rely on their own skill or
judgment that such goods are suitable for the
purchaser’s application.
Warranty Disclaimer
Paint stripe indicates
centered shaft.
Paint may or may not
be on box.
021805
Loading...