Flair Smart Vent Installation Manual

A. Smart Vent

C. 2 C Cell Batteries

E. Top Battery Holder

B. 2 Mounting Screws

D. Bottom Battery Holder

F. Battery Holder Screws

Smart Vent Installation Guide

Welcome to the Flair community!

Our users are energy nerds, home automation gurus, and HVAC Pros. If you have any questions, feel free to
check out the forums at forum.flair.co.

If you don’t see what you are looking for there, you can reach us at one of the following:

[e-mail]
[phone]
Monday-Friday, 9am to 5pm PST

What’s in the Box?

Assembly and Installation

1. Attach Bottom Battery Holder

Insert the Bottom Battery Holder into the back of
the vent. Screw in the two Battery Holder
Screws. Ensure the screws are fully inserted
and snug but do not over tighten as you might
strip the plastic.

Over →

1

2. Insert Batteries

Remove face plate if attached. Note the battery
orientation and insert the two batteries.

If you plan to wire in your vents, DO NOT insert
batteries. For further instructions on
the wired installation, see the wired installation
instructions.

3. Attach Top Battery Holder

Align the arrow on the Top Battery Holder with
the arrow on the main vent body.

Push the Top Battery Holder down over the
batteries and screw in both both screws. These
screws are attached to the Top Battery Holder
already unlike the ones from step 1. Upon
insertion, you should see the lights turn on
briefly.

4. Mount or Insert

Floor installation
Place the vent into the duct opening on the floor.

Wall and Ceiling
Insert the vent into the wall or ceiling. Using
the supplied mounting screws, insert the
screws into the mounting holes on the two
ends of the vent. Closest to the middle of the
vent is the best location in the slot but you
may need to insert the screws farther from the
center of the vent to align with existing holes.

In most cases, your existing holes should
work great. If however the mounting holes are
stripped or loose, you have options. You can
add drywall anchors to the existing holes or
you can use the alternative mounting holes on
the sides of the vent. If you opt for using the
side mounting holes, we recommend using
drywall anchors (not included) and using 4
screws (not included).

Be sure that the vent is securely fixed to the wall or ceiling. If unsure, contact a handyman or contracting
service. Flair is not liable or responsible for damage or injury resulting from vents falling from the wall or
ceiling.

2