INSTALLATION INSTRUCTIONS
PROFESSIONAL RANGE MODELS
48” ALL GAS RANGE WITH OPEN BURNERS**
48” NATURAL GAS MODELS
*TN510-7BW
*TN510-7W
**THESE MODELS ARE FIELD CONVERITBLE FOR LP/PROPANE GAS.**
48” LP/PROPANE GAS MODELS
*PN510-7BW
*PN510-7W
**THESE MODELS ARE FIELD CONVERTIBLE FOR NATURAL GAS.**
IF YOU HAVE QUESTIONS, CALL 800-251-7224, 8 AM TO 5 PM EASTERN TIME, OR VISIT OUR
WEBSITE, WWW.FIVESTARRANGE.COM.
Installation Instructions
Read these instructions completely and
carefully.
THESE RANGES SHOULD BE INSTALLED IN
CONJUNCTION WITH A SUITABLE
OVERHEAD VENT HOOD. Due to the high heat
capacity of this unit, particular attention should be paid to the hood
• IMPORTANT - Save these instructions for local
duct work installation to assure it meets local building codes.
• IMPORTANT - Observe all governing codes and
Standard countertop installations:
A 1200 CFM hood is recommended for 48" & 60" ranges.
A 600 CFM hood is recommended for 30" & 36" ranges.
• Note to Installer - Be sure to leave these instructions
Hoods should be 24" min. deep and at least the same width as the
cooktop. FiveStar hoods may be installed from 24” to 30” above the
• Note to Consumer - Keep these instructions for future
cooking surface. A minimum of 28” is required when a FiveStar
Backsplash with warming shelves is used.
• FiveStar recommends this product be installed by a
Check local building codes for the proper method of gas range
installation. Local codes vary. Installation, electrical connections and
grounding must comply with applicable codes. In the absence of local
• Product failure due to improper installation is not covered
codes, the gas range should be installed in accordance with the
National Fuel Gas Code ANSI 223.1, latest edition and National
Electrical Code ANSI/NFPA 70, latest edition.
This appliance must be properly grounded.
In the Commonwealth of Massachusetts:
These ranges weigh up to 510 pounds. Some
• This product must be installed by a licensed plumber or
gas disassembly will reduce the weight considerable. Due to
the weight and size of the range and to reduce the risk of
personal injury or damage to the produce and/or damage
• When using ball type gas shut-off valves, they shall be T
to the floor, TWO PEOPLE ARE REQUIRE FOR PROPER
• A flexible gas connector, when used, must not exceed
INSTALLATION INSTRUCTIONS
Please read these instructions
before attempting to install this
range
Inspection and Unpacking
Check the range carton for visible
damage. If there is damage or even
creases in the carton, contact the
carrier, request an inspection and file
the appropriate freight claim. Do not
refuse shipment. Responsibility for
shipping damage is with the carrier
or end user. Cut the shipping straps,
then carefully lift the carton up from
the range. This will help eliminate
possible damage to the backguard
that is packed in the top of the range
carton.
Remove, unwrap and temporarily lay
aside any parts that are not attached
to the range. Make sure no parts are
left in the carton for accidental
disposal. Carefully inspect the range
for damage.