Five Star Ranges TN047-7, PN047-7 User Manual

INSTALLATION INSTRUCTIONS

PROFESSIONAL COOKTOP MODELS

48” GAS COOKTOP WITH SEALED BURNERS**

48” NATURAL GAS MODEL

*TN047-7

**THIS MODEL IS NOT FIELD CONVERITBLE FOR LP/PROPANE GAS. IT MUST BE ORDERED

FROM THE

**THIS MODEL IS NOT FIELD CONVERITBLE FOR NATURAL GAS. IT MUST BE ORDERED FROM

THE

FACTORY SET FOR NATURAL OR LP/PROPANE.**

48” LP/PROPANE GAS MODEL

*PN047-7

FACTORY SET FOR NATURAL OR LP/PROPANE.**

I

F YOU HAVE QUESTIONS, CALL 800-251-7224, 8 AM TO 5 PM EASTERN TIME, OR VISIT OUR

WEBSITE

, WWW.FIVESTARRANGE.COM.

Installation Instructions

BEFORE YOU BEGIN CAUTION:

Read these instructions completely and
carefully.

• IMPORTANT - Save these instructions for local

inspector's use.

COOKTOPS SHOULD BE INSTALLED IN
CONJUNCTION WITH A SUITABLE

VENT HOOD. Due to the high heat capacity of this unit,
particular attention should be paid to the hood and duct

work installation to assure it meets local building codes.

OVERHEAD

• IMPORTANT - Observe all governing codes and

ordinances.

• Note to Installer - Be sure to leave these instructions

with the Consumer.

• Note to Consumer - Keep these instructions for future

reference.

• FiveStar recommends this product be installed by a

licensed professional.

• Product failure due to improper installation is not

covered under the Warranty.

In the Commonwealth of Massachusetts:

• This product must be installed by a licensed plumber

or gas fitter.

• When using ball type gas shut-off valves, they shall

be T handle type.

• A flexible gas connector, when used, must not

exceed 3 feet.

WARNING:

This appliance must be properly grounded.

Standard cooktop installations:

A 1200 CFM hood is recommended for 48" cooktops.
A 600 CFM hood is recommended for 36" cooktops.

Hoods should be 24" min. deep and at least the same width
as the cooktop.

Check local building codes for the proper method of gas
cooktop installation. Local codes vary. Installation, electrical

connections and grounding must comply with applicable
codes. In the absence of local codes, the gas cooktop should
be installed in accordance with the National Fuel Gas Code

ANSI 223.1, latest edition and National Electrical Code
ANSI/NFPA 70, latest edition

CAUTION:



disassembly will reduce the weight considerably. Due to
the weight and size of the cooktop and to reduce the risk of

personal injury or damage to the product and/or damage
to the floor, TWO PEOPLE ARE REQUIRED FOR PROPER

INSTALLATION.



Cooktops weigh up to 170 pounds. Some

INSTALLATION INSTRUCTIONS

Please read these instructions
before attempting to install this
cooktop.

Inspection and Unpacking

Check the cooktop carton for visible

damage. If there is damage or even
creases in the carton, contact the
carrier, request an inspection and file
the appropriate freight claim. Do not
refuse shipment. Responsibility for
shipping damage is with the carrier
and the dealer or end user. Cut the
shipping straps, then carefully lift the
carton up from the cooktop. This will
help eliminate possible damage.

Remove, unwrap and temporarily lay
aside any parts that are not attached
to the cooktop. Make sure no parts are
left in the carton for accidental
disposal. Carefully inspect the 48” COOKTOP = 48 3/16”

cooktop for damage.