Page 1
Y3634
Please keep this instruction sheet for future reference,
as it contains important information.
Requires one “AA” (LR6) alkaline battery
(not included) for operation.
Adult assembly is required.
Tool required for battery replacement:
Phillips screwdriver (not included).
fisher-price.com
Page 2
Assembly Setup
“T” Straps
• Fit the end of the “T” straps on
the mat through the slot in each
toy. Make sure the end of each
strap forms a “T” to secure
the toy.
Care
• The mat is surface washable
only. Wipe this toy with a clean,
damp cloth. Do not immerse.
• This toy has no consumer
serviceable parts. Do not
take apart.
• Protect the environment
by not disposing of this
product with household
waste (2002/96/EC).
Check your local
authority for recycling
advice and facilities.
WARNING
Prevent
Entanglement Injury
Do not add additional
strings or straps to
attach to a playpen.
• Slide the clips onto the play
yard wall. Push down to be sure
it is completely attached.
• Always attach all provided
fasteners (strings, straps,
clamps, etc.) tightly to a crib
or playpen according to the
instructions. Check frequently.
2
Page 3
Musical Sounds!
Power/Volume Switch
• Slide the power/volume switch to ON
with low volume
volume
• Pull the heart ring for sounds!
• When you are finished playing with
this toy, slide the power/volume
switch OFF
or ON with high
.
.
3
Page 4
Consumer Information
CONS
ASSISTANC
UMER
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
E
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifi cations not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
©2012 Mattel. All Rights Reserved. ® and ™ designate U.S.
trademarks of Mattel, except as noted.
PRINTED IN CHINA Y3634pr-0920
© Disney
4
Page 5
Battery Installation
• Locate the battery compartment
door on the back of the this toy.
Loosen the screws in the door
and remove it.
• Insert a new “AA” (LR6)
alkaline battery.
Hint: We recommend using an
alkaline battery for longer
battery life.
• Replace the battery
compartment door and tighten
the screws. Do not over-tighten.
• If this toy begins to operate
erratically, you may need to reset
the electronics. Slide the power/
volume switch off and then
back on.
• When sounds from this toy
become faint or stop, it’s
time for an adult to change
the battery.
ICES-003
• This Class B digital apparatus
complies with Canadian
ICES-003.Operation is subject
to the following two conditions:
(1) this device may not cause
harmful interference and (2)
this device must accept any
interference received, including
interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la
classe B est conforme à la
norme NMB-003 du Canada.
L’utilisation de ce dispositif
est autorisée seulement aux
conditions suivantes: (1) il ne
doit pas produire de brouillage
et (2) l’utilisateur du dispositif
doit être prêt à accepter tout
brouillage radioélectrique
reçu, même si ce brouillage est
susceptible de compromettre le
fonctionnement du dispositif.
5
Page 6
Battery Safety Information
1,5V
“AA” (LR6)
In exceptional circumstances,
batteries may leak fluids that can
cause a chemical burn injury
or ruin yourproduct. To avoid
battery leakage:
• Do not mix old and new
batteries or batteries of different
types: alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated
inside the battery compartment.
• Remove batteries during long
periods of non-use. Always
remove exhausted batteries
from the product. Dispose of
batteries safely. Do not dispose
of this product in a fire. The
batteries inside may explode
or leak.
• Never short-circuit the
battery terminals.
• Use only batteries of the
same or equivalent type,
as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable
batteries from the product
before charging.
• If removable, rechargeable
batteries are used, they are
only to be charged under
adult supervision.
6
Loading...