Fisher-price Y2189 User Manual

Owner’s Manual

with Assembly

Instructions

For Model Y2189

For Model Y21

Please read this manual and save it with your original sales receipt.

Tools needed for assembly: assembly wrench (included), Phillips Screwdriver and Adjustable Wrench (both not included).

Tools needed for assembly: assembly wrench (included), Phillips Screwdriver and Adjustable Wrench (both not included

Use only with a Power Wheels® 12 Volt Lead Acid Rechargeable Bat-tery with Built-in Thermal Fuse

and Power Wheels® 12 Volt Charger with Type 12V Connector (both included).

Product features may vary from the picture above.

ELECTRICAL HAZARD

WARNING

• Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.

• PREVENT FIRE

- Never modify the electrical system. Alterations

could cause a fire resulting in serious injury and could also ruin the electrical system.

- Use of the wrong type battery or charger could

cause a fire or explosion resulting in serious injury.

- Use of Power Wheels

other than Power Wheels overheating, fire or explosion.

• The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the battery could result in serious injury.

• Never allow children to charge the battery. Battery charging must be done by adults only. A child could be injured by the electricity involved in charging the battery.

• Read the safety instructions on the battery.

• Examine the battery, charger and their connectors for excessive wear or damage each time you charge the battery. If damage or excessive wear is detected, do not use the charger or the battery until you have replaced the worn or damaged part.

• HOT motors. Handle carefully.

RIDING HAZARD

components in products

vehicles could cause

IMPORTANT INFORMATION

• Read this manual carefully for important safety information and operating instructions before using your vehicle. Keep this manual for future reference, as it contains important information.

• The vehicle is designed for use on grass, asphalt, and other hard surfaces; on generally level terrain; and by children 3 years of age and older. Do not exceed the maximum weight capacity of 130 lbs (59 kg).

• Your new vehicle requires adult assembly. Please set aside at least 60 minutes for assembly.

• Use this vehicle ONLY outdoors. Most interior flooring can be damaged by riding this vehicle indoors. Fisher-Price not be responsible for damage to the floor if the vehicle is used indoors.

• You must charge your battery for 18-30 hours before you use your vehicle for the first time. We recommend charging your battery before beginning assembly. Please see the Battery Charging section for detailed instructions.

• The battery charger is not a toy.

• Do not short circuit the battery.

• Your Power Wheels® 12 volt battery is equipped with a built-in thermal fuse. The thermal fuse is a self-resetting safety device which automatically “trips” and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe. Once a fuse has “tripped”, remove your foot from the pedal and wait approximately 25 seconds before operating the vehicle again. To avoid repeated automatic shut-downs, avoid severe driving conditions.

• Adults Note: Regularly examine the charger for damage to the cord, plug, housing or other parts that may result in the risk of fire, electric shock or injury. In the event of any damage, do not use the charger until the damage has been properly repaired.

• If a thermal fuse in a battery continually trips under normal driving conditions, please call us at 1300 135 312.

• This vehicle has adjustable play seat belts. Please note that the adjustable seat belts are designed to be a play feature and do not function as protective safety restraints.

will

WARNING

• Prevent Injuries and Deaths

• Direct Adult Supervision Required

• Never Ride at Night.

• Keep Children Within Safe Riding Areas. These areas must be:

- away from swimming pools and other bodies of water to prevent drownings

- generally level to prevent tipovers

- away from steps, steep inclines, cars, roads and alleys.

• Riding Rules Make sure children know and follow these rules for safe driving and riding.

- Always sit on the seat.

- Always wear shoes.

- Only 2 (two) riders at a time.

Troubleshooting Î service. sher-price.com

Y2189pr-0729

PARTS

• If you experience a problem with this product, or are missing a part, please call us at 1300 135 312 rather than return this

product to the store.

• Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded.

• Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant.

Vehicle Frame 2 Valve Covers Seat

2 Front Wheels (Left and Right) 2 Rear Wheels (Left and Right) Steering Post

2 Rims Bumper Rear Axle Steering Wheel

2 Front Fenders (Left and Right)

2 Rear Fenders (Left and Right)

Hood

2 Sidebars (Left and Right)

Steering Column

Y2189pr-0729

2 Short Seat Belts Steering Wheel CapLong Seat Belt 2 Sidebar Covers (Left and Right)

Troubleshooting Î service. sher-price.com

PARTS

Fasteners Shown Actual Size

2 Front Hubcaps

2 Bushings

2 Rear Axle Caps Assembly Wrench

12V Battery 12V Charger

2 Rear Hubcaps

2 Front Axle Fastener Caps

#8 x 1,9 cm Screw – 34

#8 x 1,3 cm Screw – 2

1 cm Lock Nut – 4

#8-32 Acorn Nut – 2

For your convenience, we included extra fasteners!

Note: Tighten and loosen all screws with a Phillips

screwdriver. Do not over-tighten the screws.

Part Not Shown: Label Sheet

Troubleshooting Î service. sher-price.com

Y2189pr-0729

ELECTRICAL HAZARD

Battery must be upright while charging.

WARNING

• Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.

• PREVENT FIRE

- Never modify the electrical system. Alterations could

cause a fire resulting in serious injury and could also ruin the electrical system.

- Use of the wrong type battery or charger could cause

a fire or explosion resulting in serious injury.

- Use of Power Wheels® components in products other

than Power Wheels® vehicles could cause overheating, fire or explosion.

• The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the battery could result in serious injury.

• Never allow children to charge the battery. Battery charging must be done by adults only. A child could be injured by the electricity involved in charging the battery.

• Read the safety instructions on the battery.

BATTERY CHARGING

• Make sure you charge the battery for at least 18 hours using the enclosed Power Wheels® 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.

• Use only a Power Wheels (input 220 VAC, 50 Hz, with an output of 12 VDC) to charge your Power Wheels® 12 volt battery.

• Before charging the battery, examine the battery case for cracks and other damage which may cause sulfuric acid (electrolyte) to leak during the charging process. If damage is detected, do not charge the battery or use it in your vehicle. Battery acid is very corrosive and can cause severe damage to surfaces it contacts.

• Do not place the battery on a surface (such as kitchen counter tops) which could be damaged by the acid contained inside the battery. Take precautions to protect the surface on which you place your battery.

• Charge the battery in a well ventilated area.

12 volt charger with “12V” connector

CAUTION

Use the charger in dry locations only.

Battery must be upright while charging.

Charger Connector

• Plug the charger connector into the battery socket.

• Plug the charger into a standard wall outlet.

• Notes:

- If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.

- Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet.

• Once the battery is charged, disconnect the battery connector from the charger connector. Unplug the charger from the wall outlet. Refer to the Battery Installation section for instructions on installing your battery. If your battery is already installed in your vehicle, simply re-connect the motor harness connector to the battery.

• You do not need to remove the battery from your vehicle to recharge it.

Y2189pr-0729

Troubleshooting Î service. sher-price.com

ASSEMBLY

WARNING

Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle.

Rear Axle Cap

Motor

Rear Axle

SIDE VIEW

• Slide the rear axle through the hole in the motor in the back end of the vehicle.

• Fit a rear axle cap onto the end of the rear axle.

• Insert a #8 x 1,9 cm screw into the hole in the rear axle and tighten.

Rear Wheel

• Slide a rear wheel onto the end of the rear axle.

Troubleshooting Î service. sher-price.com

Y2189pr-0729

+ 14 hidden pages