Please keep this instruction sheet for future reference,
as it contains important information.
Requires five "AAA", three "AA"
and three LR44 button cell batteries (all included).
Adult assembly is required. Tool required: Phillips screwdriver (not included).
www.fisher-price.com
Page 2
Assembly
CAUTION
This package contains
small parts in an
unassembled state. Adult
assembly is required.
Attic Roof
1
• Slide the attic roof onto the top of the
dollhouse until it “snaps” in place.
3
• From inside the house, insert four
#6 x ½" (1,3 cm) screws into the
house and tighten with a Phillips
screwdriver. Do not over-tighten.
BACK VIEW
Door
4
• At an angle, fit the peg on top of the
door into the hole in the top of
the door frame.
• Bend the door slightly and fit the
bottom peg into the hole in the
bottom of the door frame.
2
• Fit the doorway onto the front of
the house.
Doorway
2
Page 3
3
Let’s Decorate!
• Apply labels as shown in the illustrations.
• Apply the top corners of a label first and smooth downward to remove air bubbles.
• For best results, avoid repositioning a label once it has been applied.
• The label sheet also contains several extra labels you can place where ever you like.
6
13
1
17
2
10
5
12
3
12
4
7
8
18
9
14
15
11
3
16
Page 4
4
Let’s Decorate!
24
22
19
28
24
43
19
24
25
29
2225
24
28
26
33 34 35
36
30
21212020
26
32
22
31
32
26
42
4
27
42
37
27
38
26
40
4139
Page 5
Battery Installation
When sounds or lights become faint or stop, it's time for an adult
to change the batteries. We recommend replacing the batteries
with alkaline batteries for longer battery life.
1,5V x 5
"AAA" (LR03)
Tree
Stove
• Loosen the screw in each battery
compartment door with a Phillips
screwdriver and remove it.
• Insert three, new "AAA" (LR03)
alkaline batteries in the tree and
two, new "AAA" (LR03) alkaline
batteries in the stove.
• Replace each battery compartment
door and tighten each screw. Do not
over-tighten.
• If the tree begins to operate
erratically, you may need to reset
the electronics. Slide the power
switch off and back on.
• If the stove begins to operate
erratically, you may need to reset
the electronics. Remove the
batteries and reinstall.
1,5V x 3
"AA" (LR6)
1,5V x 3
LR44 or equivalent
FireplaceWreath
• Loosen the screw in each battery
compartment door with a Phillips
screwdriver and remove it.
• Insert three, new "AA" (LR6)
alkaline batteries in the fireplace
and three, new LR44 alkaline
button cell batteries in the wreath.
• Replace each battery compartment
door and tighten each screw. Do not
over-tighten.
• If the fireplace or wreath begin to
operate erratically, you may need to
reset the electronics. Remove the
batteries and reinstall.
5
Page 6
Happy Holidays!
Press
• Slide the power switch on the tree
ON or OFF .
• Press the present under the tree for
sounds and lights.
Press
Press
• Hang the wreath on the front door.
• Press the button for lights and sounds.
Press
Press
• Press the button on the mantle to
turn the wreath and start the fire
while you listen to fun tunes!
• Press the heart button to hear
more sounds.
• Press the button on the stove top for
realistic kitchen sounds.
6
Page 7
StorageCare
• Wipe each part of this toy with a
clean, damp cloth. Pillows are
surface washable only. Do not
immerse any part of this toy.
• Protect the environment by
not disposing of this product
with household waste
(2002/96/EC). Check your
local authority for recycling
advice and facilities.
• Store everything inside the house.
• Push the sides of the house together
and latch in place.
• To open the house, lift the the side of
the house slightly to unlatch.
• To carry, simply grasp the attic floor
and lift.
Battery Safety
Information
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove
exhausted batteries from the product.
Dispose of batteries safely. Do not
dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
MER ASSISTANCE
ICES-003
• This Class B digital apparatus
complies with Canadian ICES-003.
• Operation is subject to the following
two conditions: (1) this device may
not cause harmful interference and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe B
est conforme à la norme NMB-003
du Canada.
• L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
FCC Statement (United States Only)
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications
not expressly approved by the
manufacturer responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.