3.
W3855-0920 HW EL I/S SIZE:16.5” x 8.5” COLOR: 1C+1C
PATTERN NOZZLES
a
a
1.
3
PLAY SET
Light Racers Large Scale
W3855
0920
16.5"W x8.5" H
5.5" W x8.5" H
Double
One
Black
White Offset
70 lb.
3 PANEL
Folding Dummy
Lightbrush Lab™
5
b
INSTRUCTIONS
Please keep these instructions for future reference as they contain important information.
CONTENTS
1
COVER
4
6
3
2
5 6
FRONT
2 3 4
BACK
COVER
1
4+
W3855-0920
4.
d
c
Reset
b
Paint job disappears after a while so you can do it again!
2.
a
© 2011 AM General LLC. HUMVEE®, the HUMVEE® design
and HUMVEE® trade dress are trademarks of AM General
LLC and are used under license. All Rights Reserved.
Includes 3 AAA (R03) batteries. Dispose of batteries safely.
Batteries included are for demonstration purposes only.
©2011 Mattel, Inc. All Rights Reserved.
1-800-524-8697. • Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. • Mattel
Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. • Mattel East Asia Ltd., Room
1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. • Diimport & Diedarkan Oleh: Mattel SEA
Ptd Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ.
Tel:03-78803817, Fax:03-78803867. service.mattel.com
Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations
WARNING:
CHOKING HAZARD
Not for children under 3 years.
– Small parts.
BATTERY REPLACEMENT
• Unscrew the battery cover with a Phillips head screwdriver (not included).
• Remove batteries included for demonstration purposes and dispose of them safely.
• Install 3 new AAA (LR03) alkaline batteries in the orientation (+/-) shown.
• Replace battery cover and tighten screw.
• For longer life use alkaline batteries.
• Replace batteries when lights dim or sounds become distorted.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a
chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being
charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be
used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may
explode or leak.
Protect the environment by not disposing of this product with household waste
[2002/96/EC]. Check your local authority for recycling advice and facilities.
1.
2.
ASSEMBLY
1.
2.
STENCIL DISKS
1.
Nice paint job!
For product sold in USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
For product sold in Canada • Pour les produits vendus au Canada
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.
(VALID FOR CANADA ONLY • VALABLE AU CANADA SEULEMENT)
Operation is subject to the following two conditions :
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) Il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre son fonctionnement.
2.
Hold light against stencil
for 3 seconds or more.
3.
Do not expose this toy to intense heat or direct sunlight.
These will damage the color change feature.