Fisher-Price BGJ43, BGJ55, BGX59, BHP85, CCL93 Instruction Sheet
...
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
HANGING YOUR SET.
RETAIN THIS SHEET FOR FUTURE REFERENCE.
Frequently Asked Questions Regarding 3M Command™ Strips
SURFACES
Q: To what surfaces will Command™ Products stick?
A: Painted, stained or varnished wood, tile, painted cinder block, plaster, metal,
and wallboard.
Q: Will Command™ Products stick to brick or to textured walls?
A: No. Command™ Products are intended for smooth surfaces such as those listed
above. However, products will stick to painted, smooth cinder block (the type
found inside many school buildings).
Q: Can I use Command™ Products on fresh paint?
A: Paint should be fully cured (check paint can for manufacturer's cure time) before
using Command™ Products. 3M recommends waiting a week. Also, isopropyl
rubbing alcohol may remove or dull the surface of fresh paint.
PRODUCT INFORMATION: USE AND REMOVAL
Q:
How do I remove the 3M Command™ Strips?
A:
NEVER pull the Command™ Strip toward you. Hold the bracket gently to prevent it
from snapping fingers. DO NOT press against wall. Grab tab on Command™ Strip and
SLOWLY stretch STRAIGHT DOWN along wall at least 12 inches until bracket and strip
release.
Q:
What happens if I pull too hard and the strip breaks?
A:
Simply heat up the base plate with a hair dryer to soften the adhesive. Then use
dental floss to gently cut through the foam to remove the base plate or bracket from
the surface. Stretch or peel off the remaining adhesive. DO NOT ATTEMPT TO PRY THE
BRACKET(S) OFF YOUR WALL, AS THIS WILL CAUSE DAMAGE.
Q:
Why is it recommended that I wait an hour before using the product?
A:
The 1-hour wait ensures that the adhesive has had enough time to build strong
adhesion to the wall or surface.
If cleaning is necessary, 3M recommends using isopropyl rubbing alcohol.
Q:
Why can't I clean the surface with a household cleaner?
A:
Many household cleaners leave behind a very thin layer of residue that affects how
strongly the adhesive will bond to the surface. 3M recommends using isopropyl
rubbing alcohol.
Q: Can I use Command™ Products on wallpaper?
A: No.
CLIMATE AND TEMPERATURE
Q: Can I use Command™ Products outside in cold climates?
A: You can, but the adhesive should be applied to a clean, smooth, dry surface when
the temperature is above 50°F (10°C). If the temperature is below 50°F, you can
heat the surface with a hair dryer before application.
Q: Can I use Command™ Products outside in hot climates?
A: Extreme heat conditions and sunlight may cause the adhesive to eventually
deteriorate, causing product failure. The adhesive could soften and lose adhesion
above 105°F (40°C).
Q:
Is there latex in Command™ Strips?
A:
No. Command™ Strips contain an adhesive that is a synthetic rubber resin and does
not contain natural rubber latex.
For further information or questions visit service.mattel.com or call 1-800-524-8697
(US and Canada Only).
WORKS BEST ON SMOOTH SURFACES.
DO NOT USE WITH WALLPAPER.
MAY NOT ADHERE WELL TO VINYL SURFACES.
3M and Command are trademarks of 3M.
© 3M 2012. All Rights Reserved.
©2012 Mattel. All Rights Reserved.
00007-2811
Loading...