BATTERY INSTALLATION
Unscrew and lift cover away from products.
Install batteries as indicated inside the battery compartment.
For longer life use only alkaline batteries.
If this toy begins to operate erratically, you may need to reset the electronics.
Remove the batteries from the toy and replace it.
Requires 3 "AA" (LR6) and 3 "AAA" (LR03) batteries.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressively approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
• THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
• CET APPAREIL NUMERIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU
CANADA.
• Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
• L’utilisation de ce produit est sujette aux conditions suivantes : (1) il ne doit pas produire de brouillage et
(2) il doit pouvoir tolérer tout brouillage reçu, même si ce brouillage est susceptible de compromettre son
fonctionnement.
Thomas
Gordon
Remote Control
1,5V x 3
“AA” (LR6)
Required tool:
Phillips screwdriver
(not included)
Spencer
James
1,5V x 3
“AAA” (LR03)
TM
Remote Control Motorized Engine
INSTRUCTIONS
Please keep these instructions for future reference as they contain important information.
V7627 Thomas W2630 Gordon
V7628 James
V7629 Spencer
SYMPTOM SOLUTION
Engine drives slowly
Engine does not respond
to the remote controller
The wheels on the engine or attached cars may be dirty. Wipe them with a clean cloth.
• Re-start the engine by switching it "OFF (
shuts off automatically.
• Battery power in the remote controller or in the engine may be weak. Replace ALL THREE batteries in controller and engine with
fresh, alkaline batteries.
• You may be beyond the maximum range of the remote controller (about 12 feet).
• You may not have a clear path between the engine and the remote controller. This toy works best when there are no obstructions
between the engine and the remote. Operate the toy by holding the controller 2-feet minimum horizontally above the train.
• Try dimming the lights in the room. Bright sunlight or fluorescent lights may effect the range of the remote controller.
NOTE: (i) Remote control engines only operate with the TrackMaster™ remote. They do not move on their own. (ii) Interference
may occur and performance start to degrade if more than two characters are used at the same time in the same vicinity.
Based on the Railway Series by The Reverend W Awdry.
© 2011 Gullane (Thomas) Limited. Thomas the Tank Engine & Friends
and Thomas & Friends are trademarks of Gullane (Thomas) Limited.
© HIT Entertainment Limited. HIT and the HIT logo are trademarks
of HIT Entertainment Limited.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052, U.S.A.
PRINTED IN CHINA.
Manufactured for Fisher-Price.
© 2011 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc., unless otherwise indicated.
Mattel East Asia Ltd., Room 1106, South Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
o)" & "ON (ı)". If you do not operate the remote controller for a few minutes, the engine
Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
V7626
ID. V7626-0920G1
REMOTE CONTROL INSTRUCTION
1
Fast
2
Faster
3
Fastest
Neutral
R
Reverse
Engines may derail on tight turns using
the FASTEST speed. Slow the engines
down when making tight turns.
Engines may not stop on a track with a
STOP switch while riding at full speed.
Slow the engines down when using a
STOP switch.
06/24/11 Remark for G1
- added “Gordon”
Item No : V7626-0920G1
Version : EL
Size : 8.27" x 11.69" (A4)
Paper : Woodfree paper 70 gsm
Color : Black
Date : 07/14/2011 (BC)