Fisher-Price W2622 User Manual
W2622
• Please keep this instruction sheet for future reference, as it
contains important information.
• Requires four “C” (LR14) alkaline batteries for mobile
operation and two "AAA" (LR03) alkaline batteries for
remote operation (batteries not included).
• Adult assembly is required for battery replacement.
• Tool required: Phillips screwdriver (not included).
• Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse.
• This toy has no consumer serviceable parts. Do not take
this toy apart.
fisher-price.com
Mobile Hub
Parts
Arm
Spinner
Crib Connector
Remote
Base
Note: All of the screws used to assemble this toy are attached to the product.
Follow these instructions carefully to fully secure the screws. Tighten and
loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
2
Battery Installation
Hint: We recommend using alkaline batteries for longer battery life.
1,5V x 4
“C” (LR14)
• Loosen the screws in the mobile base battery compartment door with a Phillips
screwdriver and remove it.
• Insert four "C" (LR14) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
• Loosen the screw in the remote battery compartment door with a Phillips
screwdriver and remove it.
• Insert two "AAA" (LR03) alkaline batteries.
• Replace the battery compartment door and tighten the screw.
Note: Under normal use conditions, the batteries in the mobile base will
require replacement more often than the batteries in the remote. When
sounds, lights, projection or movement become faint or stop, it’s time for an
adult to change the batteries.
• If this product begins to operate erratically, you may need to reset the
electronics. Slide the power/volume switch on the base off and then back
on. Remove the batteries from the remote and reinstall them.
• Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check
recycling advice and facilities.
your local authority for
1,5V x 2
"AAA" (LR03)
3
Assembly
SLIDE
Base
Crib Connector
1
• Fit the crib connector to the base and tighten both screws.
IMPORTANT! Make sure the straps are over the top of the crib connector.
B
SLIDE
A
PRESS
Arm
Socket
2
• First, press the button on the mobile base A and then slide the socket door open B.
• Fit the arm into the socket in the base and tighten both screws.
4
Loading...