Page 1
V7505
Actual product may appear different
than the product shown.
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
www.fisher-price.com
Page 2
Assembled Parts
Handlebar - 2 Pieces
Assembly
CAUTION
This package contains small parts in its
unassembled state. Adult assembly is required.
Take extra care during unpacking and assembly.
Body
Seat
Body
Base
#8 x 1/2” Screws – 11
Shown Actual Size
Note: Tighten and loosen all
screws with a Phillips screwdriver.
Do not over-tighten screws.
Base
1
• Fit the body onto the base, as shown.
Base
2
• While holding the body and base together, carefully tip the
assembly over.
• Insert six screws into the holes in the base and tighten.
2
Bottom View
Page 3
Assembly
Seat
3
• Turn the assembly upright.
• Fit the seat onto the assembly.
• Insert two screws into the holes on each side of the seat
and tighten.
B
Short
Handlebar
Long
Handlebar
A
4
• First, insert the long handlebar
through the hole in the pony head A.
Hint: You may need to turn the long handlebar to fit it into
the hole.
• Then, insert the short handlebar through the hole on the
other side of the pony head B.
• While holding the handlebars in place, carefully tip the pony
so that the short handlebar faces up.
• Insert a screw into the hole in the short handlebar
and tighten.
3
Page 4
Battery Replacement
For best performance, we recommend that you replace the
batteries that came with this toy with three, new “AA” (LR6)
alkaline batteries.
• Locate the battery compartment side of the pony.
• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
• If toy begins to operate erratically, you may need to reset the
electronics. Slide the power/volume switch on the toy off and
then back on.
• When sounds become faint or stop, it’s time for an adult to
change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
Battery Safety Information
1,5V x 3
“AA” (LR6)
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of
batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
4
Page 5
Power/Volume
Switch
• Slide the power/volume
switch on the toy to on
with low volume ; on
with high volume
or off .
Roll-Along with Music
Press the
button on the
pony's head for
musical tunes.
5
Page 6
Consumer Information
C
E
ONSUMER ASSISTANC
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Care
• Wipe with a clean cloth dampened with a mild soap and
water solution. Do not immerse.
FCC Statement (United States Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
ICES-003
• This Class B digital apparatus complies with Canadian
ICES-003 . Operation is subject to the following
two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NMB-003
• C et appareil numérique de la classe B est conforme à la
norm e NMB-003 du Canada. L’utilisation de ce dispositif est
autorisée seulement aux conditions suivantes: (1) il ne doit
pas produire de brouillage et (2) l’utilisateur du dispositif doit
être prê t à accepter tout brouillage radioélectrique reçu,
meme si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. V7505pr-0920
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Loading...