BATTERY INSTALLATION
Unscrew and lift cover away from top of Thomas.
Install battery as indicated inside the battery compartment.
For longer life use only alkaline batteries.
Requires 1 “AA” (LR6) battery.
If this toy begins to operate erratically, you may need to reset the electronics.
Remove the batteries from the toy and replace it.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury
or ruin your toy (product). To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged
(if designed to be removable).
• Rechargeable batteries are only to be charged under adult supervision (if designed to
be removable).
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
NOTE: Changes or modifications not expressively approved by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
• THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
• CET APPAREIL NUMERIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU CANADA.
• Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired operation of the
device.
• L’utilisation de ce produit est sujette aux conditions suivantes : (1) il ne doit pas produire de brouillage et
(2) il doit pouvoir tolérer tout brouillage reçu, même si ce brouillage est susceptible de compromettre son
fonctionnement.
Thomas
1,5V x 1
“AA” (LR6)
Required tool:
Phillips screwdriver
(not included)
On
TM
INSTRUCTIONS
Please keep these instructions for future reference as they contain important information.
Off
Assembly
Lift the braking section of the track onto the tab of the Chocolate Factory, as shown.
Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority for
recycling advice and facilities (Europe only).
Based on the Railway Series by The Reverend W Awdry.
© 2010 Gullane (Thomas) Limited.
Thomas the Tank Engine & Friends and Thomas & Friends are
trademarks of Gullane (Thomas) Limited.
© HIT Entertainment Limited.
HIT and the HIT logo are trademarks of HIT Entertainment Limited.
Fisher-Price, Inc., a subsidiary of Mattel, Inc.,
East Aurora, NY 14052 U.S.A.
PRINTED IN CHINA.
Manufactured for Fisher-Price.
©2010 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc.,
unless otherwise indicated.
Mattel East Asia Ltd., Room 1106,
South Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
CAUTION:
To prevent entanglement,
keep hair away from wheels.
V6453
ID.V6453-0920
NOTE: This is a “one-time snap” assembly.
Once these pieces are snapped together,
they cannot be taken apart.
ADULT ASSEMBLY REQUIRED.
No tools required for assembly.
Item No : V6453-0920
Version : EL
Size : 16.54" x 11.69" (A4)
Paper : Woodfree paper 80 gsm
Color : Black
Date : Oct. 4, 2010 (WC)
Track Layout
2. Slide the BRAKE SWITCH to the STOP position.
3. Slide the power switch on Thomas forward to the ON position.
4. THOMAS will travel around the track until he reaches the CHOCOLATE FACTORY and
will stop by the brake switch.
NOTE: Adults should remove & discard rubber bands holding tracks together.
How To Play
1. Set THOMAS and the cargo car on the track so they are traveling in a counter-clockwise
direction.
STOP
5. Drop the cargo through the roof of the CHOCOLATE FACTORY.
It will drop down and load into the cargo car.
6. Slide the BRAKE SWITCH to the GO position and THOMAS will be on his way!
GO