Page 1
9
3
1
2
1
1
1
3
R9369
Please keep this instruction sheet
for future reference, as it contains
important information.
Requires three "AA" (LR6) alkaline
batteries (not included).
Adult assembly is required for
battery installation.
Tool required for battery installation:
Phillips screwdriver (not included).
www.fisher-price.com
Page 2
Battery Installation Battery Safety
Information
1.5V x 3
“AA” (LR6)
In exceptional circumstances, batteries
may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
BOTTOM VIEW
• Locate the battery compartment on the
bottom of the toy.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three "AA" (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• If this product begins to operate
erratically, you may need to reset the
electronics. Slide the power/volume
switch off and then back on.
• When sounds or lights become faint or
stop, it’s time for an adult to change
the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
•
Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Page 3
Assembly Power/Volume
BOTTOM VIEW
1
1
• Press and turn
the dial on the
bottom of the
toy to release
and lengthen the cord.
• Locate the power/volume switch on
the bottom of the toy.
• Slide the switch to ON with
low volume or ON with high
volume
• When finished playing with this toy,
slide the power/volume switch OFF .
.
2
1
• Squeeze the
stem and inflate
the ball.
• Fit the end of the cord through
the slot on the ball so that it
forms a "T."
Page 4
1
3 Ways to Play!
1
Sit & Bop
• Press and turn the dial on the
bottom of the toy to lock the
ball firmly to the base. Baby
can bop the ball for fun lights
and sounds.
1
2
Tethered Play
• Press and turn the dial on the bottom
of the toy to release and lengthen the
cord. Baby can push or bat the ball or
crawl around after it while enjoying
music and lights.
Page 5
3 Ways to Play!
1
3
• Remove the cord from the ball. Baby
can bounce, throw or bat the ball.
Ball Play
Page 6
Consumer Information
Care
• Wipe this toy with a clean cloth
dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
ICES-003
• This Class B digital apparatus
complies with Canadian ICES-003.
• Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada.
•
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est
susceptible de compromettre le
fonctionnement du dispositif.
FCC Statement (United States only)
This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void
the user’s authority to operate the
equipment. This device complies with
Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052 U.S.A. R9369pr-0920
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Loading...