Consumer
Battery Safety
Information
WARNING
Prevent Entanglement Injury
• This product may not attach
to all crib designs. Do not
add additional strings or
straps to attach to a crib
or playpen.
• Use ONLY attached to a crib.
Please keep this instruction sheet •
for future reference, as it contains
important information.
Requires four “C” batteries (included) •
and two “AAA” (LR03) alkaline batteries
(not included) for operation.
Adult assembly is required for •
battery installation.
Tool required for battery installation: •
Phillips screwdriver (not included).
Information
In exceptional circumstances, batteries
may leak fl uids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
Do not mix old and new batteries or •
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
Insert batteries as indicated inside the •
battery compartment.
Remove batteries during long periods •
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fi re. The batteries inside
may explode or leak.
Never short-circuit the battery terminals.•
Use only batteries of the same or •
equivalent type, as recommended.
Do not charge non-rechargeable •
batteries.
Remove rechargeable batteries from the •
product before charging.
If removable, rechargeable batteries are •
used, they are only to be charged under
adult supervision.
2
Soother Battery
Remote Battery
Replacement
1.5V x 4
"C" (LR14)
For best performance, we recommend
replacing the batteries that came with
the soother with four, new “C” (LR14)
alkaline batteries.
Locate the battery compartment on the •
back of the soother.
Loosen the screws in the battery compart-•
ment door and remove the door.
Remove the exhausted batteries and •
throw them away.
Insert four, new “C” (LR14) •
alkaline batteries.
Hint: We recommend alkaline batteries
for longer battery life.
Replace the battery compartment door •
and tighten the screws.
If the soother begins to operate •
erratically, you may need to reset the
electronics. Slide the power/volume
switch off and then back on.
IMPORTANT! Under normal use conditions,
the batteries in the soother will require
replacement more often than the batteries
in the remote. When sounds and lights from
this toy become faint or stop, it’s time for
an adult to change the batteries.
Installation
1.5V x 2
“AAA” (LR03)
Locate the battery compartment on the •
back of the remote.
Loosen the screw in the battery compart-•
ment door and remove the door.
Insert two, new “AAA” (LR03) •
alkaline batteries.
Hint: We recommend alkaline batteries
for longer battery life.
Replace the battery compartment door •
and tighten the screw.
If the remote begins to operate erratically, •
you may need to reset the electronics.
Remove the batteries and replace them.
3