Page 1
Consumer Information
Care
Wipe this toy with a clean cloth dampened
with a mild soap and water solution.
Do not immerse this toy.
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes:
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif.
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help. Note: Changes
or modifications not expressly approved
by the manufacturer responsible for
compliance could void the user’s authority
to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference and (2) this
device must accept any interference received,
including interference that may cause
undesired operation.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA M5664a-0920
Page 2
Please keep this instruction sheet for future reference,
Requires three "AA" batteries (included) for operation.
as it contains important information.
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).
www.fisher-price.com
Page 3
Battery Replacement
Note: A plastic tab was attached to the toy for in-store demonstration purposes. While the
tab may have already been removed, check the back of the toy to be sure. If the plastic tab
is still attached, open the fasteners on the back of the toy and pull to remove the tab. Close
the fasteners and throw the plastic tab away.
1.5V x 3
"AA" (LR6)
For best performance, we recommend that you replace the batteries that came with this
toy with three, new "AA" (LR6) alkaline batteries.
• Open the fasteners on the back of the toy.
• Pull the sound box out of the toy to access the battery compartment.
• Loosen the screws in the battery compartment door. Remove the battery compartment
door and the exhausted batteries.
• Pull tether strap to remove batteries. Discard the batteries.
• Replace tether strap in bottom of battery compartment.
• Insert three “AA” (LR6) alkaline batteries. Make sure the bottom battery is inserted
on top of the tether strap.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw.
• Fit the sound box back into the toy and close the fasteners.
• If the product begins to operate erratically you may need to reset the electronics.
Slide the power switch off and then back on.
• When sounds or lights become faint or stop, it’s time for an adult to change the batteries!
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).
Page 4
Soothe Baby with Lullabies and Ocean Sounds
• Open the fasteners on the back of the toy to access the sound box.
• Pull sound box out of toy to access the switches.
• Slide the power switch on .
• Adjust the volume switch to low volume or high volume .
• Fit the sound box back inside the toy and close the fasteners.
• Squeeze the belly on the sea horse for lights and music.
Hint: If you cannot see the lights, open the fasteners and adjust the sound box to align the
light with the sea horse tummy.
• When you are finished playing with the toy, open the fasteners and slide the
power off .
Battery Safety Information
In exceptional circumstances, batteries may leak fl uids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
Loading...