Fisher-Price P9043 User Manual
P9043
1
www.fi sher-price.com
Consumer Information
WARNING
Prevent serious injury or death from
falls or sliding out:
• Only use for a child capable of sitting
upright unassisted.
• NEVER leave child unattended.
High Chair Use:
• ALWAYS secure child with restraint
belts adjusted to t your child snugly.
The tray is not designed to hold child
in the product.
When attached to adult chair:
• Use restraint belts until child is able to
get in and out of the product without
help (about 2
1
/2 years old).
IMPORTANT! PLEASE KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
• Please read these instructions before assembly and use of
this product.
• Adult assembly is required.
• Tool needed for assembly: Phillips screwdriver (not included).
• When using this product on an adult chair:
- Make sure the chair seat is level and larger than the seat base.
- DO NOT use on a folding chair.
- Check to be sure the floor surface beneath the chair is level.
• Product features and decorations may vary from photographs.
• NEVER use in motor vehicles.
• ALWAYS secure the product on
a chair using bottom and back
attachment straps. NEVER use
on a stool or bench that does not
have a seat back.
2
Assembled Parts
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Front Base
Hint: Do not remove the plastic inserts
inside the tubes of the front base.
Footrest
Seat Back with Restraint
Rear Base
Seat with Restraint
Tray
Seat Support
2 Frames
Hint: Do not remove the plastic
insert inside the tube in each frame.
#8 x ¾" Screw with Plastic Retainer – 4
Note: Tighten and loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
Seat Pad
FASTENERS SHOWN ACTUAL SIZE
3
Seat Back Pad
#8 x ¾" Screw – 4
Assembly
CAUTION
This package contains small parts
in its unassembled state.
Adult assembly is required.
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or
sharp edges. DO NOT use if any parts are missing or broken.
Contact Fisher-Price® for replacement parts and instructions
if needed. Never substitute parts.
2
Tapered Frame Tube
Rear Base
1
• With the Fisher-Price® logo facing out, fit the tapered frame tube
into the rear base.
• Fit a #8 x ¾" screw with retainer into the rear base and tighten.
• Repeat steps 1 and 2 to assemble the other frame to the rear base.
Seat Support
Frame Latches
Frame Tubes
Frame Assembly
3
• Lay the frame assembly down with long frame tubes up.
• Position the seat support with the frame latches down.
• Slide the seat support onto the frame tubes.
Hint: Push the seat support all the way to the top of the assembly.
You will hear several "clicks".
4
Front Base
4
• Fit the front base into the frame tubes.
Assembly
Seat Support
Footrest
6
• Lift the frame assembly upright.
• Fit the footrest onto the seat support, as shown.
5
• Insert two #8 x ¾" screws with retainers into the holes in each
frame tube and tighten.
Hint: If you cannot insert the screws into the frame tubes, you have
assembled the front base backwards. Remove it, turn it around and
re-assemble it to the frame tubes.
Footrest
7
• Insert two #8 x ¾" screws into the holes on each side of the
footrest and tighten.
5
Loading...