Fisher-Price P6033 User Manual

P6033

WARNING

IMPORTANT! KEEP INSTRUCTIONS
FOR FUTURE REFERENCE.

www.fi sher-price.co.uk

Consumer Information

WARNING

To prevent serious injury from
falls and being strangled in the
restraint system:

• Always use the restraint system.

• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lbs).

• Never leave child unattended.

• It is dangerous to use this product
on an elevated surface.

• Please read these instructions before assembly and use of
this product.

• Adult assembly is required.

• Tool required for assembly: Phillips screwdriver (not included).

• Requires four LR14 “C” alkaline batteries for operation
(not included).

• Weight Limit: 9 kg (20 lbs).

IMPORTANT! The maximum weight limit for this product is
9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but is
really active and appears to be able to climb out of the swing,
immediately discontinue its use.

• Product features and decoration may vary from photo.

Care

The pad and is machine washable. Wash the pad separately in
cold water on the gentle cycle. Do not use bleach. Tumble dry
separately on low heat and remove promptly. The frame can be
wiped clean using a mild cleaning solution and a damp cloth.
Do not immerse this product.

To remove the pad:

• Lift the footrest and remove the pad lower pocket.

• Push the restraint belts back through the pad.

• Turn the seat face down. Unfasten the buckle. Turn the
seat upright.

• Slide the pad upper pocket off the seat back tube.

To re-assemble the pad:

• Refer to assembly steps 8 and 9.

Great Britain: Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303. www.service.mattel.com/uk.

Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.

New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Asia: Mattel East Asia Ltd, Room 1106, South Tower,

World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Malaysia: Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.

(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran
Tropicana Golf Country Resort, 47410 PJ.
Tel: [phone], Fax: [phone].

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.

©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

PRINTED IN CHINA P6033pr-0726

2

Parts

CAUTION

This package contains small parts in
its unassembled state. Adult assembly
is required.

IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.

Assembly

IMPORTANT! Before assembly, inspect this product for damaged

hardware, loose joints, missing parts or sharp edges. DO NOT use
if any parts are missing or broken. Contact Mattel for replacement
parts and instructions if needed. Never substitute parts.

Front Leg

Back Leg

1

2 Swing Frames

Seat Frame

2 Base Tubes

Note: Tighten or loosen all screws with a Phillips screwdriver.

Do not over-tighten the screws.

Seat Pad

• Slide the front and back legs on the swing frame outward until
they "click" into place.

• Repeat this procedure to open the other swing frame.

Press Buttons on Front Legs

Base Tube

2

• While pressing the buttons on the end of each front leg, insert the
front legs into the ends of one of the base tubes.

• Push the front legs down into the base tube until the buttons

"click" into place.

#6 x 3 cm Screw – 2

Shown Actual Size

3