Fisher-Price P5755 User Manual
P5755
IMPORTANT!
KEEP INSTRUCTIONS
FOR FUTURE REFERENCE.
www.fi sher-price.co.uk
Consumer Information
WARNING
Prevent serious injury or death from
falls or sliding out:
• The child should at all times wear a
safety harness correctly fitted and
adjusted. The tray is not designed to
hold the child in the chair.
• It is recommended that only children
capable of sitting upright unassisted use
the high chair in the upright position.
• Always keep child in view while using
the high chair.
• Never leave child unattended.
• Do not use the high chair unless all
components are correctly fitted and
adjusted.
Prevent injury from burns: Do not place
this high chair near open fires or any
hot surfaces.
IMPORTANT! Place the high chair on a level, stable surface away
from electrical flexes. Be sure to keep electrical flexes out of
child's reach.
• Please read these instructions before assembly and use of
this product.
• Adult assembly is required.
• Tool needed for assembly: Phillips Screwdriver (not included).
• Product features and decorations may vary from the photograph.
2
Assembled Parts
CAUTION
This package contains small parts in its unassembled state. Adult assembly is required.
Back Base
Footrest
Hinge Rod
Front Base
Food Tray Base Tray
2 Seat Bottom Tubes
2 FramesPad Seat Bottom Seat Back
Note: Tighten or loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
#8 x 1,9 cm Screws – 8 #10 x 2,2 cm Black Screw – 7
Shown Actual Size
3
Assembly
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Fisher-Price®
for replacement parts and instructions if needed. Never substitute parts.
Footrest
Seat Bottom
1
• Place the seat bottom face down on a flat surface.
• At an angle, fit the footrest on the seat bottom, as shown.
Plastic Rings
Seat Bottom Tubes
Plastic Rings
2
• Slide a seat bottom tube through each set of plastic rings on the
seat bottom.
3
• Align the holes in the plastic rings and the seat bottom tubes.
• Insert a #8 x 1,9 cm screw through each plastic ring and into
the seat bottom tubes, as shown. Tighten the screws. This may
require extra force.
• Push the seat bottom tubes back and forth to be sure they are
secured to the seat bottom. If the seat bottom tubes move,
you have probably not fastened them properly. Remove the
screws and check to be sure the screw holes in the seat bottom
tubes and seat bottom plastic rings are aligned. Replace and
tighten the screws.
4
Insert Screws Here
Assembly
Hinge
Hinge Rod
4
• Insert two #10 x 2,2 cm black screws through the footrest and
into the seat bottom. Tighten the screws. This may require
extra force.
Seat Back Pin
Slot
Slot
6
• Turn the seat assembly face down.
• Insert the hinge rod through the hinge on the seat back and seat
bottom, as shown.
• Insert a #10 x 2,2 cm black screw into the hinge rod. Tighten
the screw.
• Set the seat assembly aside for Assembly step 9.
Seat Bottom Assembly
5
• Turn the seat bottom assembly upright.
• Fit the seat back pins into the slots in the top side of the seat
bottom assembly.
5
Loading...