Consumer Information
Assembled Parts Battery Replacement
Battery Installation
www.fisher-price.com
Please keep this instruction sheet for future reference, as it contains important information.
Requires six “AAA” alkaline batteries (not included) and three button
cell batteries (included) for operation.
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
This Class B digital apparatus complies with
•
Canadian ICES-003.
Operation is subject to the following two
•
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B est
•
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée
•
seulement aux conditions suivantes : (1) il
ne doit pas produire de brouillage et (2)
l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the •
equipment and receiver.
Consult the dealer or an experienced
•
radio/TV technician for help.
Note: Changes or modifi cations not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Care
Wipe this toy with a clean, damp cloth.
•
Do not immerse the vehicles or
remote controller.
This toy has no consumer serviceable parts.
•
Do not take this toy apart.
Mountain
Y Track
Railroad Track
2 Guard Rails
3 Straight Tracks
Crossover Track
2 Ramp Tracks
4 Curve Tracks
2 Trestles
Bridge Track
(Lightning McQueen and Remote Controller)
1.5V x 6
“AAA” (LR03)
Lightning McQueen
Loosen the screws in the bottom of •
the vehicle with a Phillips screwdriver.
Remove the top of the vehicle off
of the chassis to access the battery
compartment. Insert three “AAA”
(LR03) alkaline batteries.
Replace the top of the vehicle and tighten
•
the screws with a Phillips screwdriver.
Do not over-tighten.
IMPORTANT! Under normal use conditions, the batteries in Lightning McQueen will require
replacement more often than the batteries in the remote controller.
Remote Controller
Locate the battery compartment on the •
bottom of the remote controller.
Loosen the screw in the battery compartment
•
door with a Phillips screwdriver. Remove the
battery compartment door and insert three
“AAA” (LR03) alkaline batteries.
Replace the battery compartment door and
•
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
(Sheriff)
1.5V x 3
LR44 or equivalent
Sheriff
Loosen the screws in the bottom of the •
vehicle with a Phillips screwdriver. Remove
the top of the vehicle off of the chassis to
access the battery compartment.
Remove the exhausted batteries and
•
throw them away.
Insert three, new button cell (LR44)
•
alkaline batteries.
Replace the battery compartment door
•
and tighten the screws. Do not
over-tighten.
Notes:
We recommend using
• alkaline batteries for longer battery life.
When sounds/lights/movement become faint or stop, it's time for an adult to change
•
the batteries.
If the vehicles or the remote controller operate erratically, you may need to reset the
•
electronics. Remove the batteries and replace them.
Protect the environment by not disposing of this product with household waste •
(2002/96/EC).Check your local authority for recycling advice and facilities
(Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak fl uids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:
Do not mix old and new batteries or batteries of different types: alkaline, standard
•
(carbon-zinc) or rechargeable (nickel-cadmium).
Insert batteries as indicated inside the battery compartment.
•
Remove batteries during long periods of non-use. Always remove exhausted batteries from •
the toy. Dispose of batteries safely. Do not dispose of the product in a fi re. The batteries
inside may explode or leak.
Never short-circuit the battery terminals.
•
Use only batteries of the same or equivalent type, as recommended.•
Do not charge non-rechargeable batteries.•
Remove rechargeable batteries from the toy before charging.•
If removable, rechargeable batteries are used, they are only to be charged under •
adult supervision.
1 2 3 4 5
Assembly and Setup
Track Layout
All Aboard!
Troubleshooting
Mountain
1 32
Fit the mountain onto the bridge track. Push •
to “snap” in place.
Bridge Track Trestles
•
At an angle, fi t the tab on a trestle into
the slot on the mountain. Push to “snap”
in place.
Repeat this procedure to assemble the
•
other trestle to the mountain.
Guard Rail
Curve Track
•
Fit each guard rail onto each curve track,
as shown.
Hint: We do not recommend using the vehicles on carpets. For best performance, use on the
track provided or hard, fl at surfaces.
POWER BUTTONREADY LIGHT
4-Position Remote Controller
➋ ➌
➊
➍
➊ Forward
(vvith Sound Effects)
➋ Forward
➌ OFF
➍ REVERSE
Place the vehicles on the track.•
Press the power button on top of the Lightning McQueen car. The ready light turns on.•
Hold the remote controller with the stick facing you. Point the remote controller toward the •
vehicle and push the stick forward. The vehicle moves forward around the track.
Pull the stick back a little to stop the vehicle.
•
Pull the stick all the way back and the vehicle travels in reverse. Release the stick to stop.•
Hints:
If you do not operate the remote controller for a few minutes, the vehicle shuts off and
•
the ready light turns off. Press the vehicle power button and operate the remote controller
to restart.
This toy works best if you have a clear path between the remote controller and the vehicle.
•
Point the remote controller at the vehicle. The maximum range of the remote controller •
is about 12 feet (3.66 m).
Wipe the toy with a clean, damp cloth. Do not immerse.
•
PROBLEM SOLUTION
Vehicle drives
slowly
Vehicle does
not respond
to the remote
controller
Battery power in the vehicle may be weak. Replace all three batteries
in the vehicle with fresh, alkaline batteries.
The wheels on the vehicle may be dirty. Wipe them with a clean cloth.
Battery power in the remote controller may be weak. Replace all
three batteries in the remote controller with fresh, alkaline batteries.
You may be beyond the maximum range of the remote controller,
which is about 12 feet (3.66 m).
You may not have a clear path between the remote controller and
the vehicle. This toy works best when there are no obstructions
between the vehicle and the remote controller.
Bright sunlight or fl uorescent lights may affect the range of the
remote controller. Try dimming the room you are playing in.
The vehicle may have shut off. If you do not operate the remote
controller for a few minutes, the vehicle shuts off automatically and
the ready light turns off. Press the power button on the vehicle, and
operate the remote controller to restart.
4
Fit the ramp tracks onto the ends of the bridge track. •
Disney/Pixar elements ©Disney/Pixar, not including underlying vehicles owned by third parties: Hudson Hornet™, Chevrolet Impala™,
PRINTED IN CHINA P5370a-0920
Porsche™, Mercury™, and Jeep
©2009 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc., unless otherwise indicated.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©Disney/Pixar
®
. Sarge’s rank insignia design used with the approval of the U.S. Army
6 7 8 9 10
5
Push down on Sheriff to hear fun phrases! •
Track pieces easily snap together.•