CAUTION
This package contains small parts in
its unassembled state. Adult assembly
is required.
P5066
KIT PARTSCONSUMER INFORMATION
8 Washers 2 Wrenches
Adult assembly is required.
Tools needed for disassembly/assembly: 2 Wrenches
(included); Slotted Screwdriver (not included).
If you need further assistance, please contact Power Wheels®
Consumer Relations, toll-free at 1-800-348-0751. Or, contact
your local Power Wheels® authorized service center. For the
location nearest you, please visit us on-line at
www.powerwheels.com, or call 1-800-348-0751.
Washers shown actual size.
1
• Turn the vehicle over.
• While squeezing the edges on a hubcap, insert a slotted
screwdriver under a tab. Repeat to remove all three tabs on
the hubcap.
• Pull to remove the hubcap.
• Repeat step 1 to remove the remaining hubcaps.
3
• Slide two washers onto the end of each front axle.
2
• Using one of the wrenches, loosen the hex nut on a front axle.
• Remove the hex nut.
• Repeat this procedure to remove the hex nut on the other
front axle.
4
• Replace the hex nut onto each front axle.
• Tighten both hex nuts with the wrench.