Page 1
P2803
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "AA" (LR6) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly and battery replacement:
Phillips screwdriver (not included).
www.fi sher-price.com
Page 2
Parts
CAUTION
This product contains small parts in its unassembled state.
Adult assembly is required.
Handles
Seat Top
Keyboard
Base
#6 x 2½" Shoulder Screw
All fasteners are shown actual size.
Tighten all screws with a Phillips screwdriver.
Do not over-tighten the screws.
3 Legs
2
Seat Bottom
Bar
3
8
#6 x " Screw
Page 3
Battery
Battery Safety
Installation
Battery Compartment Door
1.5V x 3
"AA" (LR6)
• Locate the battery compartment on the
bottom of the toy.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three "AA" (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power/mode switch off and
then back on.
• When sounds from this toy become faint
or stop, it’s time for an adult to change
the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
3
Page 4
Assembly
Bar
Tapered End
1
1
• Place the base on a flat surface.
• Insert the tapered end of the bar into the
large opening in the base, as shown.
Base
Legs
1
3
• Insert and "snap" the tabs on each of
the legs into the slots in the base.
Handles
1
2
1
4
Keyboard
• Insert the #6 x 2
through the hole in the base. Tighten
the screw.
PRINTED IN CHINA P2803a-0920
½" shoulder screw up
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
• Place the keyboard on a flat surface.
• Insert and "snap" the handles into
the keyboard.
4
Page 5
5
Assembly
1
1
7
• Position the keyboard over the legs,
as shown.
• Press down on the keyboard to "snap" it
onto each leg. Pull up on the piano to be
sure it is secure.
Seat Top
1
6
• Fit the seat top onto the seat bottom.
• Turn the seat assembly over and insert
the two #6 x " screws into the holes
in the seat bottom. Tighten the screws.
Seat Bottom
3
8
• Fit the groove in seat bottom onto the
bar as shown.
PRESS
FIRMLY
1
8
• Press down firmly on the back of the
seat to secure the seat to the bar. You
should feel the seat “snap” in place.
• Pull up on the seat to be sure it is secure.
Note: The seat will fit in two positions.
Adjust the seat forward or back, to your
child’s comfort.
5
Page 6
Rock and Play Piano
Rock the piano
while you
play along!
Song Book
Turn the page to select
another song.
Flip out the feet
and play like
a real piano!
Instrument Selector
Choose from piano, violin,
harp, tuba or flute.
Flip-out Feet
Flip the feet down for
stationary piano play.
6
Page 7
Power/Mode Switch Volume Switch
Slide the power/mode switch to:
Rock & Play – Press a key to listen
to a whole song play.
Build-a-Song – Press the keys to
hear part of a song. Press again to
hear more.
Freeplay – Press the keys to play
your own songs, just like
a real piano.
When finished playing with this toy,
slide the power/mode switch off.
• Locate the volume switch under
the keyboard.
• Slide the volume switch to low volume
or high volume .
Care
• Wipe this toy with a clean cloth
dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
7
Page 8
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that
may cause undesired operation.
ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that
may cause undesired operation.
NMB-003
Cet appareil numérique de la classe Best conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes: (1) il ne doit pas
produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement
du dispositif.
8
Loading...