Fisher-Price P1370 User Manual

www.fisher-price.com

P1370

P1370

Please keep this instruction sheet for future reference, as it contains important information.

Requires six “AAA” (LR03) alkaline (not included).

Adult assembly is required.

Tool required for battery installation: Phillips screwdriver (not included)

1

Assembled Parts

Shack

Curved Track – 5

Straight Track – 4

Short Track – 2Small Trestle – 2

Upper Mountain Lower Mountain

Curved Elevation Track

Large Trestle – 2

Easy Rail Station Station Track Piece

2

Ramp Track with

Guardrails – 2

Battery Installation

1.5V x 6

“AAA” (LR03)

IMPORTANT! Under normal use conditions, the batteries in the vehicle will require
replacement more often than the batteries in the remote controller.

• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).

Engine

• Locate the battery compartment on
the back of the Engine.

• Loosen the screws in the battery

compartment door with a Phillips
screwdriver. Lower the battery
compartment door and insert three
“AAA” (LR03) alkaline batteries.

• Close the battery compartment door

and tighten the screws with a Phillips
screwdriver. Do not over-tighten.

• If this product begins to operate
erratically, you may need to reset the
electronics. Remove the batteries and
replace them in the toy.

Remote Controller

• Locate the battery compartment on
the bottom of the remote controller.

• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door and insert three
“AAA” (LR03) alkaline batteries.

• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.

• If this product begins to operate
erratically, you may need to reset
the electronics. Remove the batteries
and replace them in the toy.

3

Battery Safety Information

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:

• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).

• Insert batteries as indicated inside the battery compartment.

• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Dispose of batteries safely. Do not dispose of the product in a fire. The batteries
inside may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or equivalent type, as recommended.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy before charging.

• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.

ICES-003

This Class B digital apparatus complies with Canadian ICES-003.•
Operation is subject to the following two conditions: (1) this device may not cause harmful •

interference and (2) this device must accept any interference received, including interference that
may cause undesired operation.

NMB-003

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.•
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas •

produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement
du dispositif.

4