• For proper setup and use, please read these instructions.
• Please keep this instruction sheet for future reference, as it contains important information.
• Transmitter operates on AC current. Receiver operates on AC current (use enclosed AC adaptor) or
3.6V NiMH rechargeable battery pack (included).
• Before fi rst time use, charge the rechargeable battery pack for four hours.
• Adult assembly is required for wall mounting. Tools needed for assembly: electric drill, ¼" drill bit,
hammer, Phillips screwdriver (tools not included).
• This product is not intended to be used as a medical monitor and its use should not replace
adult supervision.
• Test sound/audio reception of receiver before fi rst-time use and whenever you change location of
the transmitter.
• Adults Note: Periodically examine this product for damage to the cord, housing or other parts that may
result in the risk of fi re, electric shock or injury. If the product is damaged, do not use it.
• Never use extension cords with the AC adaptor.
• Never use transmitter or receiver near water (i.e. bathtub, sink, wet basement, etc.).
• Always use transmitter and receiver where there is adequate ventilation. To prevent overheating,
keep away from heat sources such as radiators, heat registers, direct sunlight, stoves, amplifi ers,
fi re, excessive heat or other appliances that produce heat.
• Fisher-Price
• Always remember that you are using public airwaves when using your monitor. Conversations, even from
rooms near your transmitter, may broadcast to other nursery monitors, radios, cordless telephones or
scanners outside your home. To protect the privacy of your home, always turn off the transmitter when
not in use.
• Do not connect to more than the recommended number of power supplies.
• The AC adaptor is not a toy.
• Disconnect the AC adaptor from the receiver before cleaning.
• If this product begins to operate erratically, you may need to reset the electronics. Turn the transmitter
power/volume dial off and then back on; press the receiver main power/menu button to turn power off
and press again to turn power back on.
• Carrier Frequency: 2.4 Ghz
• Product features and decoration may vary from photos.
®
does not recommend the use of two monitors in one house.
3
Features
6
7
2
13
5
14
9
10
11
3
4
ReceiverTransmitter
AC Adaptor/Charger
1
8
4
Transmitter Tabletop Stand
12
4
Features
Main Power/Menu Button – Press to turn receiver main power ON; press again for the main
1
menu; press and hold for approximately fi ve seconds to turn main power OFF.
Power L.E.D. – Turns on when receiver power is ON.
2
Menu Navigation/Volume Control Button – Press up, down or side arrows to scroll through menu
3
options. When the menu is not on the screen, press the side arrows to adjust volume.
Speaker
4
Video Screen
5
Video Screen On/Off Button – Press to turn the video screen on; press again to turn it off.
6
Sound Lights – Shows you baby's sounds.
7
DC Input Jack – Insert the AC adaptor/charger pin to use AC power/charge the battery.
8
Camera Lens
9
Power/Volume Dial – Rotate to turn transmitter power ON and adjust volume to a comfortable
10
level for baby.
Microphone
11
Music, Sounds and Night Light Buttons
12
Music – Choose from 5 lullaby songs.
Sounds – Play nature sounds.
Night Light – Turn on night light for baby.
Power L.E.D. – Turns on when transmitter power is ON.
13
Night Light – Lights room with a soft glow.
14
5
Wall Mount Parts
Wall Mount BracketCord WrapBase Stand
Fasteners Shown Actual Size
Wall Anchor – 4
#8 x 2" Screw – 4
6
Charging the Battery
(Inside the Receiver)
DC Input Jack
IMPORTANT! Fully charge the receiver (with battery pack inside) for four hours before fi rst-time use.
Use only the included AC adaptor charger! Do not use any other adaptor charger.
• Fit the AC adaptor charger pin into the DC input jack on the receiver.
• Plug the AC adaptor charger into a standard wall outlet.
Notes: If power fl ow to the wall outlet is controlled by a switch, make sure the switch is “ON”. Use the AC
adaptor charger only in a wall outlet. Do not plug the AC adaptor charger into a ceiling outlet. To connect
to a supply that is not in the United States, use an adaptor (not included and sold separately) with the
proper confi guration for the power outlet.
• If you are monitoring baby while charging the battery pack, you will see the charging icon
video screen.
7
on the
Testing Sound/Video Reception
Test transmitter transmission and receiver reception before installing the wall mount bracket
• Place the transmitter in the room where you intend to use it.
• Point the transmitter toward the area you will be monitoring. Adjust the camera angle by rotating the top
portion of the transmitter up or down.
• Turn the power/volume dial ON.
• Turn on a radio.
and cord wrap (if used) and each time you change location of use.
Power Dial
Radio
8
Testing Sound/Video Reception
Sound Lights
Main Power/Menu Select
Button
• Place the receiver in the room where you intend to use it.
• Press the main power/menu select button on the front of the receiver to turn power ON.
• Adjust the receiver location for best reception.
• When sound is picked up by the receiver, the sound lights will turn on.
- One or two lights indicate quieter sounds.
- Three or more lights indicate louder sounds.
• If you cannot see an image on the receiver screen, adjust the transmitter location or camera angle.
9
Transmitter Wall Mount Installation
WARNING
To prevent strangulation with power cord, never
place transmitter within reach of child.
IMPORTANT! Test the reception of the monitor before installing the wall mount bracket and cord wrap.
Use the assistance of one adult to hold the transmitter against the wall in the spot you want to install it.
Then, test the reception of the receiver in several locations around your house. Please refer to the Testing
Sound/Video Reception section of these instructions.
10
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.