Page 1
www.fisher-price.com
Please keep this instruction sheet for future reference,
N8853
as it contains important information.
Requires six "AA" (LR6) alkaline batteries
(not included) for car operation.
Adult assembly is required.
Tool required for battery installation:
Phillips screwdriver (not included).
This product is not recommended for use
on loose dirt or wet surfaces.
Actual product may vary from the photos.
Page 2
Assembly
Each track piece has a number on the bottom. Simply match the numbers and fit the pieces together!
Hint: For best performance, we suggest assembling the track on a hard, flat surface.
Fit the banner sign
into the matching
holes on the track.
Fit the barrels onto
the track.
Fit the guard rails into the
matching holes on the track.
Fit the banner sign
into the matching
holes on the track.
Page 3
Battery Installation Battery Safety Information
1.5V x 6
"AA" (LR6)
Battery
Compartment
Door
• Locate the battery compartment door on the bottom of
each car.
• Loosen the screw in the battery compartment door
with a Phillips screwdriver. Remove the battery
compartment door.
• Insert three "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
• If the toy begins to operate erratically, you may need to
reset the electronics. Slide the power switch off and
then back on.
• When sounds or motions from the car become faint or
stop, it’s time for an adult to change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Page 4
Just For Fun!
1
• Slide the power switch on the bottom of each car ON .
2
• Lift the car and shake it to start the "engine" and the
sound effects.
Hint: For maximum distance, shake the car 7 or 8 times.
Shaking more than this does not increase the distance
it will travel.
3
• Set the car on the track and watch it go. Fun sound
effects add to the excitement!
• When your car stops, pick it up, shake it and set it down
again to restart.
• When you're finished playing, slide the power switch on
each car OFF .
Page 5
Race to Win!
Starting Gate
1
• Slide the power switch on the bottom of each car ON .
2
• Lift the car and shake it to start the "engine" and the
sound effects.
Hint: For maximum distance, shake the car 7 or 8 times.
Shaking more than this does not increase the distance
it will travel.
3
• Lift the both starting gates on the track.
• Set the cars on the arrows behind the starting line.
• When both cars are ready, press the pedal and you're off.
• When your car stops, pick it up, shake it and set it down
again to rejoin the race.
• When you're finished playing, slide the power switch on
each car OFF .
Hint: You can also race your cars on any smooth, flat surface.
Shake the car, set it down and let it go.
The car travels up to 20 feet!
Starting Gate
Page 6
Consumer Information
Care
• Wipe this toy with a clean cloth dampened with a mild
soap and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take
this toy apart.
FCC Statement (United States Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
ICES-003
• This Class B digital apparatus complies with Canadian
ICES-003.
• Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
DC SUPER FRIENDS and all related characters and
elements are trademarks of and © DC Comics.
WB SHIELD: TM & © Warner Bros. Entertainment Inc.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA N8853pr-0920
Loading...