• Please keep this instruction sheet for future
reference, as it contains important information.
• Requires three “AA” (LR6) alkaline batteries
for operation (not included).
• Tool required for battery installation: Phillips
screwdriver (not included).
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement
aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement
du dispositif.
FCC Statement (United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
2
Page 3
Assembled Parts
2 Animal Panels
3 TubesHubBear Toy
Quilt
3
Page 4
• Locate the battery compartment door on the
back of the bear toy.
• Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• If this toy begins to operate erratically, you may
need to reset the electronics. Slide the power/
volume switch off and then back on.
• When sounds from this toy become faint
or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Safety InformationBattery Installation
1.5V x 3
“AA" (LR6)
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or
ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbonzinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.