Page 1
Manny’s
Repair Shop
Manny’s
Manny’s
Repair Shop
Manny’s
Manny’s
Repair Shop
Repair Shop
Repair Shop
Please keep this instruction sheet for future reference, as it contains important information.
Requires three “AA” (LR6) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
1
www.fisher-price.com
Page 2
4 Legs
Assembled Parts
Shelf
Workbench Top
Manny
Drill
Saw
#6 x 5/8" (1.6 cm) Screws - 4
Tighten and loosen all screws with a Phillips screwdriver.
Do not over-tighten.
Visit the Disney Web site at www.disney.com
PRINTED IN MEXICO N3658pr-0920
©2009 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc., unless otherwise indicated.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© Disney
2
Page 3
PUSH
CAUTION
CHOKING HAZARD - Small Parts.
Not suitable for children under 3 years.
Shelf
Leg
1
• Fit a leg onto the shelf, as shown.
Assembly
3
• Fit the workbench top onto the leg assembly.
Hint: The “V” shape in the shelf should be facing the back
of the assembly (under the battery door) when attaching
the workbench top.
• Push to "snap" the workbench top to the leg assembly
(near each leg).
PUSH
PUSH
Workbench Top
"V" Shape
Facing Back
PUSH
PUSH
Screw
2
• Insert a screw into the leg and tighten.
• Repeat this procedure to assemble the remaining legs to
the shelf.
Drill
Manny
Saw
4
• Fit the saw, drill and Manny into the slots on the workbench.
Push each to “snap” in place.
3
Page 4
Battery Installation
FCC Statement
1.5V x 3
“AA” (LR6)
• Locate the battery compartment on the back of the toy.
• Loosen the screw in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three, new “AA” (LR6) alkaline batteries.
Hint: We recommend alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw.
• If this product begins to operate erratically, you may need
to reset the electronics. Slide the power switch off and then
back on.
• When sounds from this toy become faint or stop, it’s time
for an adult to change the batteries.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities (Europe only).
United States Only
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
ICES-003
• This Class B digital apparatus complies with Canadian
ICES-003.
• Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose
of batteries safely. Do not dispose of product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
•
Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
NMB-003
• Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux
conditions suivantes : (1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement du dispositif.
4
Page 5
Help Build & Fix Projects!
• Slide the power switch on the back of the "diagnostic center"
ON .
PRESS
• Insert a blueprint into the “diagnostic center” and press
the check button to hear how to build your projects.
Manny will tell you what to do!
• After each step, press the check button to hear Manny's
instructions for the next step.
• Use the tools and “wood” pieces to build different projects!
• We've included printed blueprints to help you build!
• Use the included screwdriver to "fix" the saw and the drill
when they "break down".
5
Page 6
Storage Consumer Information
• Use the slots and the compartments in the shelf to store
your supplies!
• Store blueprints in the slot behind the "diagnostic center".
Care
• Wipe this toy with a clean cloth dampened with a mild soap and
water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
6
Loading...