Fisher-Price N2170 Instruction Sheet

Download

Page 1

N2170

N2171

Each sold separately and subject to availability.

Please keep these instructions for future reference,

as they contain important information.

Requires two “AA” batteries (included) for operation.

Adult assembly is required for battery replacement.

Tool required for battery replacement:

Phillips screwdriver (not included).

www.fisher-price.com

Page 2

Battery

Replacement

For best performance, we recommend replacing the batteries that came with this toy with two, new alkaline “AA” (LR6) batteries.

• Locate the battery compartment on the back of the toy.

• Loosen the screws in the battery compartment door. Remove the battery compartment door.

• Remove the exhausted batteries and throw them away.

• Insert two "AA" (LR6) alkaline batteries.

Hint: We recommend using alkaline batteries for longer battery life.

• Replace the battery compartment door and tighten the screws.

•

If the toy begins to operate erratically, you may need to reset the electronics. Slide the power switch off and then back on.

• When sounds from this toy become faint or stop, it’s time for an adult to change the batteries.

• Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).

Battery Safety

Information

1.5V x 2

"AA" (LR6)

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

• Insert batteries as indicated inside the battery compartment.

• Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of product in a fire. The batteries inside may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or equivalent type, as recommended.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the product before charging.

• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.

Page 3

Gate

Push

Gate

Rolling, Roaring Fun!

Push

Gate

• Slide the power switch on the back of the toy on .

• Lower the gate and push the lever to let the animals out and listen to animal and other fun sounds.

• Attach the bird to the side of the habitat wall.

• When finished playing, slide the power switch on the back of the toy off .

Page 4

Consumer Information

Care

• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse this toy.

• This toy has no consumer serviceable parts. Do not take this toy apart.

FCC Statement

United States Only

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.