Fisher-Price N0459 User Manual
N0459
www.fisher-price.com
www.fisher-price.comwww.fisher-price.com
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Tool required for assembly: Phillips Screwdriver (not included).
Water or sand to fill base (not included).
IMPORTANT!
Rim height should be adjusted
only
by an adult.
Product features and decoration may vary from the photograph above.
N0459
N0459
Product features and decoration may vary from the photograph above.Product features and decoration may vary from the photograph above.
Please keep this instruction sheet for future reference, as it contains important information.
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Adult assembly is required.
Tool required for assembly: Phillips Screwdriver (not included).
Tool required for assembly: Phillips Screwdriver (not included).
Water or sand to fill base (not included).
Water or sand to fill base (not included).
IMPORTANT!
IMPORTANT! Rim height should be adjusted only by an adult.
Rim height should be adjusted
only
by an adult.
Assembled Parts
Hint: Some parts were placed inside the lower post for shipping.
Backboard
Net/Ring
Assembly
Lower PostUpper Post
#6 x 1/2" Screw - 4
#8 x 3/4" Screw - 4
BOTH SHOWN ACTUAL SIZE
Note: Tighten all screws with a Phillips
screwdriver. Do not over-tighten the screws.
Rim
Sure Score™ Rim
Base
Note: Label sheet not shown.
2
CAUTION
Assembly
This product contains small parts
in its unassembled state.
Adult assembly is required.
1
3
1
Proper label application will help to keep the label looking
its best!
• Carefully peel a label from the label sheet and attach it to
the backboard, as shown.
• Smooth out the label to remove any air bubbles.
• Repeat this procedure to apply the remaining labels to
the backboard.
Label
Backboard
2
4
Ring
Ring Tab
2
• Place the loops at the top of the net into the grooves on
the ring.
• Pull each loop through a ring tab, as shown.
Net Assembly
Rectangular
Tabs
Rim
3
• Place the rim on a flat surface with the rectangular tabs
facing up.
• Locate the four holes in the underside of the net assembly.
Align the four holes in the underside of the net assembly with
the four holes in the rim.
• Place the net assembly onto the rim.
3
Holes
Loading...