Mickey’s
Mickey’s
Surprise Clubhouse
Surprise Clubhouse
Please keep these instructions for future reference as they contain important information.
BEFORE YOU BEGIN
• Remove and discard the “Try Me” pull-tab, located on the bottom of the STAGE next
to the battery compartment (see battery diagram). Once the “Try Me” pull tab is
removed, the toy will perform its full play pattern as described below.
• Be sure the ON/OFF switch is in the ON position. The ON/OFF switch is also located
on the bottom of the STAGE, next to the battery compartment.
TRY ME
pull tab
WHAT’S INCLUDED?
3 Figures:
HOW TO PLAY
• Open the front GATES and the walkway to the Clubhouse
will magically appear!
• Place the figures on their pedestals to hear character phrases.
NOTE: Each character has only one pedestal that it will fit on.
• Slide the Pedestal Lever on the front of the STAGE to move
the pedestals up and down and hear the “Hot Dog” song.
• Press the Talk Button found on the stage to hear additional
phrases from the characters.
• Pull the Picnic Table Lever to pop up the picnic table.
• Pull the Doghouse Lever to pop up Pluto’s doghouse.
NOTE: You can purchase additional
figures separately and place them on
Pluto’s pedestal to hear Mickey welcome
you to the clubhouse.
Pluto’s Pedestal
Mickey’s Pedestal
Minnie’s Pedestal
Talk
Button
Mickey
Minnie
Pluto
Base
HOW TO ASSEMBLE
1. Attach the STAGE to the BASE, as shown.
2. Attach the GARAGE to the BASE, as shown.
3. Attach the GATES to the BASE, as shown.
4. Insert the HOT-AIR BALLOON SUPPORT ARM
into the top of the STAGE, as shown.
Stage
Hot-air Balloon
With Support Arm
Garage
Gates
Car
Doghouse Lever
Pedestal Lever
Picnic
Table Lever
BATTERY INSTALLATION
Unscrew and lift cover away from bottom of product.
Replace batteries as indicated inside the battery compartment.
Batteries included are for demonstration purposes only.
For longer life use only alkaline batteries.
Requires 3 “AA” (LR6) batteries.
Required tool: Phillips screwdriver (not included)
1.5V x 3
“AA” (LR6)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Mattel Inc. 333 Continental Blvd. El Segundo, CA (310) 252-2400
NOTE: Changes or modifications not expressively approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
• THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
• CET APPAREIL NUMERIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU CANADA.
• Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
• L’utilisation de ce produit est sujette aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir
tolérer tout brouillage reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your toy
(product). To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged (if designed to be removable).
• Rechargeable batteries are only to be charged under adult supervision (if designed to be removable).
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this toy in a fire. The batteries inside may explode or leak.
ID. M9888-0920G1
ADULT ASSEMBLY REQUIRED.
No tools required for assembly.
© Disney
Visit the Disney Web site at www.disney.com
Fisher-Pr ice, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
PRINTED IN CHINA.
Manufactured for Fisher-Price. ©2008 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc., unless otherwise indicated.
For countries outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303.
www.service.mattel.com/uk
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria. 3121 Australia.
Consumer Advisory Service - 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Asia: Mattel East Asia Ltd., Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
08/14/08 Remark for G1
- Revised line art drawing
- Updated FCC statement
Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Item : M9888-0920G1
Version : EL
Size : A4
Paper : Woodfree Paper 80 gsm
Color : 1C
Date : Aug 14, 2008 (WC)
M9888