K3795
M8743
WARNING
PLEASE KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.
www.fi sher-price.com.au
Consumer Information
WARNING
Prevent serious injury or death from falls or sliding out:
• Always secure child with the restraint belts until child is able to get in and out of
the product without help (about 2
child in the product.
• Never leave child unattended.
• Always secure the product on a chair using the bottom and back attachment
straps. Never use the product on a stool or bench that does not have a seat back.
• Only use upright position when child is capable of sitting upright unassisted.
Prevent serious injury or death:
• Do not use in motor vehicles.
1
/2 years old). The tray is not designed to hold
2
2
Consumer Information
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or
sharp edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and instructions if needed.
Never substitute parts.
• Please read these instructions before assembly and use of
this product.
• Adult assembly and setup is required. No tools needed for
assembly or setup.
• Product features and decorations may vary from photos.
• Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
• New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Care
Parts
Tray
Pad
• The pad, seat, seat back and straps may be wiped clean
using a mild cleaning solution and damp cloth. Do not
use bleach. Do not use harsh or abrasive cleansers. Rinse
clean with water to remove residue.
• The tray is top rack dishwasher safe (or use the bottom
rack - without using the drying cycle).
To remove the pad:
• Push to remove the shoulder straps from the slots on the
waist restraint buckle.
• Lift the top of the pad off of the seat back.
• Fit the shoulder belts back through the slots in the pad.
• Unfasten the pad hooks from the front edge of the seat.
• Unbuckle the waist belts from the crotch belt.
• Fit the crotch belt down through the slot in the pad.
• Fit the waist belts back through the slots in the pad.
• Remove the pad from the seat.
• To replace the pad: refer to Assembly steps 2 - 6.
IMPORTANT! Never use this product without the restraint
system. Replace the crotch, waist and shoulder belts for
high chair use; replace the crotch and waist belts for
booster seat use.
Seat Back with Restraint System
Seat with Restraint System and Attachment Straps
3
Assembly
Seat Back
Ta b
Slot
Seat
Large Tab
Ta b
Slot
1
• Fit the seat back tabs into the slots in the top of the seat.
•
Push the top of the seat back so that the large tab “snaps”
into place in the seat.
Lowest Slots
Waist Belts
Crotch Belt
3
• Fit the waist belts on the seat through the lowest slots
in the pad. Make sure the waist belts are not twisted.
• Fit the crotch belt on the seat through the large slot
in the pad. Make sure the crotch belt is not twisted.
2
Pad
Hooks
4
• Fit the pad onto the seat.
• Fasten the hooks on bottom of the pad to the front edge
of the seat.
4
Assembly
Upper Slots
Adjusting the Seat Height
Base
Latches
5
• Insert the shoulder belts through the slots in the pad.
- Use the lower shoulder belt slots for a smaller baby.
- Use the upper shoulder belt slots for a larger baby.
• Make sure the shoulder belts are not twisted.
Shoulder Belt
Slot
Lower Slots
Adjusterr
6
Base
Side View
• While squeezing the latches together with one hand, lift or
lower the base.
Hint: This will require some force. You may want to pull
one latch and lift or lower one side of the base. Then
repeat this procedure to lift or lower the other side of
the base.
• Release the latches to lock the base in place
• While adjusting seat height, you may accidentally pull the
base completely off of the seat bottom. If this should happen,
simply squeeze the latches together and fit the base back
onto the seat bottom.
• Locate the longer portion of the shoulder belt, under-
neath the adjuster.
• Fit the end of this longer portion through the slot in the
top of the waist belt.
Hint: If the end does not fit at all through the slot, you
are probably inserting the wrong end. Make sure you
insert the longer portion of the belt through the slot.
• Repeat this procedure to attach the other shoulder belt
to the other waist belt.
5
Attaching to a Chair
WARNING
Prevent serious injury or death
from falls or sliding out: Always
secure the product on a chair using
bottom and back attachment straps.
Never use the product on a stool
or bench that does not have a
seat back.
Bottom Straps
1
IMPORTANT! Place the product on a chair on a level, stable
surface, away from electrical flexes. Be sure to keep electrical
flexes out of child’s reach.
• Place the seat on a chair.
• Wrap the bottom straps around the bottom of the chair .
Buckle the straps . Make sure you hear a "click". Pull
the free end of the strap to tighten on the chair .
Back Straps
2
• Wrap the back straps around the back of the chair .
Buckle the straps . Make sure you hear a "click."
Pull the free end of the strap to tighten on the chair .
6
Adjust Seat Recline
WARNING
Prevent serious injury or death from
falls or sliding out: Only use upright
position when child is capable of sitting
upright unassisted.
Upright
Semi-Recline
Seat Recline Latch
PULL
• While pulling the seat recline latch, push the top of the
seat back to lower in the desired position. Or, while pulling
the seat recline latch, push the bottom of the seat to lift in
the desired position.
• Release the seat recline latch.
• Push on the seat back to be sure the seat is secure.
Hint: You may not be able to fully recline this product on
some kitchen chairs.
Recline
7
Adjust Armrests
PRESS
Armrest Button
• While pressing the armrest button, rotate the armrest
forward or backward to the desired position.
• Repeat this procedure to adjust the other armrest.
Upright Seating
Semi-Recline Seating
Recline Seating
8
Secure Child
WARNING
Prevent serious injury or death from
falls or sliding out:
Adjuster
•
Always secure child with the
restraint belts until child is able to
get in and out of the product without help (about 2
1
/2 years old). The
tray is not designed to hold child
in product
.
• Never leave child unattended.
Waist Belt
Waist Belt
Anchored End
Free End
To tighten the waist belts:
• Feed the anchored end of the waist belt up through the
buckle to form a loop . Pull the free end of the waist
belt .
• To tighten the shoulder belts: Hold the adjuster
and pull the front shoulder strap down .
Adjuster
TIGHTEN
eCrotch Belt
• Place your child in the seat. Position the crotch belt
between your child’s legs.
• Buckle the restraint belts to the crotch belt. Make sure
you hear a "click" on both sides.
• Check to be sure the restraint system is securely attached
by pulling it away from your child. The restraint system
should remain attached.
Anchored End
Free End
To loosen the waist belts:
• Feed the free end of the waist belt up through the buckle
to form a loop . Enlarge the loop by pulling on the
end of the loop toward the buckle. Pull the anchored
end of the waist belt to shorten the free end of the waist
belt .
• To loosen the shoulder belts: Lift the adjuster .
Note: After adjusting the restraint system to fit your child,
make sure you pull on it to be sure it is securely fastened.
9
LOOSEN
Tray Use
Hint: Before first time use, wash the tray thoroughly with
soap and water. The tray is top rack dishwasher safe (or use
the bottom rack - without using the heated drying cycle).
WARNING
Prevent serious injury or death
from falls or sliding out: Always
secure child with the belts until
child is able to get in and out of the
booster seat without help (about 2
years old). The tray is not designed
to hold child in the booster seat.
1
/2
Tray Button
Tray
1
Armrests
2
Tray Latches
• You can adjust the tray forward or backward.
- While pressing the button on the front of the tray, push
or pull the tray forward or backward.
- While squeezing both latches underneath the tray, push
or pull the tray forward or backward.
Tray Button
• Fit the tray onto the armrests. Push down until the tray
“snaps” into place.
Note: The tray is not microwave safe.
3
• While squeezing both latches underneath the tray,
pull to remove.
10
Tray Latches
Convert to Booster Seat
This high chair easily converts to a booster high chair
for toddlers.
Shoulder Belts
2
Shoulder Belts
• Fit the shoulder belts back through the slots in the pad.
• Lift the top of the pad off of the seat back.
3
Hooks
1
• Push to remove the shoulder belts from the waist restraint
buckle slots.
• Unfasten the pad hooks from the front edge of the seat.
• Unbuckle the waist belts from the crotch belt.
11
Convert to Booster Seat
Waist Belts
Crotch Belt
Seat Back
Ta b
Seat
Back View
5
• Pull the tab on the seat back. Lift to remove the seat back
from the seat.
• Store the seat back, pad and shoulder belts in a safe place
for future use.
4
• Fit the crotch belt down through the slot in the pad.
• Fit the waist belts back through the slots in the pad.
• Remove the pad from the seat.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA K3795a-0729
12
Loading...