Fisher-Price M7932 User Manual

M7932

WARNING

IMPORTANT! KEEP INSTRUCTIONS FOR

FUTURE REFERENCE.

www.fisher-price.co.uk

Consumer Information Parts

WARNING

To prevent serious injury or death:

• Fall Hazard - It is dangerous to use this

product on an elevated surface, since child’s
movement may cause the product to slide or
tip over. Use only on a floor.

• Suffocation Hazard - Never use on a soft

surface (bed, sofa, cushion) since the
product can tip over and cause suffocation
in soft surfaces.

• Never leave child unattended.

• Never use as a carrier or lift while child is

seated. Never use the toy bar as a handle.

• Always use the restraint system.

• Never use as a car seat.

• Not recommended for children who can sit

up by themselves (6 months approximately,
until 9 Kg/20 lbs).

IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.

Pad

Toy Bar

3 Toys (Toys may be different)

Seat Back Tube

CAUTION

This package contains small parts in its
unassembled state. Adult assembly is required.

• Please read these instructions before assembly and use of
this product.

• Adult assembly is required. Tool needed for assembly: Phillips
screwdriver (not included).

• Requires one "D" (LR20) alkaline battery (not included)
for operation.

• Product features and decorations may vary from photo.

Retainers

Footrest

Left
Base Wire

Tighten and loosen all screws with a Phillips screwdriver.

Base Tube

2 Feet

Do not over-tighten the screws.

M5 x 20 mm Screw – 4

Shown Actual Size

Right Base Wire

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A. M7932pr-0726
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA

2

Assembly

IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel
for replacement parts and instructions if needed. Never
substitute parts.

Base Tube

Left Base Wire

1

• Place the base tube on a flat surface.

• Position the left and right base wires as shown.

• Fit the left base wire and right base wire into the base tube.

Feet Holes

Right Base Wire

3

• Insert an M5 x 20 mm screw through each foot and tighten.

Footrest

Base Wires

2

• Position the feet so the holes are toward you and the non-skid
surface is down.

• Fit the feet on the base tube, as shown.

4

• Position the footrest so that the soothing unit is upright.

• Fit the footrest onto the ends of the base wires.

3