Fisher-Price M7333 Instruction Sheet

Please keep this instruction sheet for future reference, as it contains
important information.

Requires three “AAA” (LR03) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).

www.fisher-price.com

Ladder

Parts

3 Flags

Roof

2 Walls

Battery Safety Information

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:

• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon­zinc) or rechargeable (nickel-cadmium).

• Insert batteries as indicated inside the battery compartment.

• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries
inside may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or equivalent type, as recommended.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the product before charging.

• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.

Battery Installation

1.5V x 3

“AAA” (LR03)

• Locate the battery compartment on the bottom of the toy.

• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.

• Insert three “AAA” (LR03)

Hint: We recommend using alkaline batteries for longer battery life.

• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.

• When sounds from this toy become faint or stop, it’s time for an adult to change the batteries.

• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).

alkaline batteries.

Assembly

Hinges

1

1

• Fit together the hinges on the front and back of the castle.

Flag

Roof

Slots

1

2

• “Snap” the roof into the slots in the tower.

• Insert the flags into the top of each roof.

Ladder

Flags

1

3

• Attach the ladder to the castle wall.

Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. M7333pr-0920
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA

A Royal Party with Music and Dancing!

Power/Volume Switch

Slide the power/volume switch

Slide the power/volume switch

on the bottom of the toy to on

on the bottom of the toy to on

with low volume , on with

with low volume , on with

high volume

high volume

, or off O.

, or off O.

Slide to lever to dance to

the music in the ballroom.

Neigh!

Hear the pony call

you from the stables.

Press the jewelry box

for fun sounds.

Consumer Information

Care

• Wipe the toy with a clean cloth dampened with a mild soap and water solution.

• Do not immerse the toy.

FCC Statement (United States Only)

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for

compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.