Consumer Information
WARNING
To prevent serious injury or death:
• Fall Hazard - It is dangerous to use
this reclined cradle on an elevated
surface, since child’s movement may
cause product to slide or tip over.
Use only on a floor.
• Suffocation Hazard - Never use on
a soft surface (bed, sofa, cushion)
since the product can tip over and
cause suffocation in soft surfaces.
• Never use the toy bar as a handle.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lbs).
IMPORTANT! Please keep these instructions for future
reference, as they contain important information.
• Please read these instructions before use of this product.
• Adult assembly is required. Tool needed for assembly:
Phillips Screwdriver (not included).
• Requires three “C” (LR14)
for operation.
• Product features and decoration may vary from photos.
alkaline batteries (not included)
CAUTION
This package contains small parts in
its unassembled state. Adult assembly
is required.
2
Parts
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Some parts may be packed inside the pad.
Infant Support
Seat Pad
Butterfly Toy
Seat Back Tube
Toy Bar
4 mm x 30 mm Screw – 2
4 mm x 20 mm Screw – 2
Shown Actual Size
Base Tube
Soothing Unit
Front Base
3
Assembly
IMPORTANT! Before assembly, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact
Mattel for replacement parts and instructions if needed.
Never substitute parts.
Turn Tube Ends Up
Front Base
1
• Place the seat back tube face down, as shown.
• Turn the ends of the tube upright.
Seat Back Tube
2
• Insert the ends of the front base into the holes in the handles.
Hint: If you cannot insert the front base into the handles,
turn the seat back tube over and try again!
• Insert two 4 mm x 20 mm screws through the hole in the
handles and the ends of the front base. Tighten the screws.
Hint: If the screw does not easily insert through the hole
in the handle and front base, you may not have pushed
the front base completely into the handle. Push the front
base into the handle to align the holes and then insert
the screw.
Seat Back Tube Handles
4