Fisher-Price L5805 User Manual

Super Sounds
Soccer
Super Sounds
Soccer
Super Sounds
Super Sounds
Soccer
Super Sounds
Super Sounds
Soccer
Soccer
Soccer
Model L5805
www.fisher-price.com
www.fisher-price.com
1
PARTS
PARTS
PARTS
Target
Net
Tube with Tapered End and
Regular End (Upper)
Ball
2 Tubes with Tapered Ends
(Upper and Lower)
• Please keep this instruction sheet for future reference, as it contains important information.
• Adult assembly is required.
• Tool needed for assembly: Phillips Screwdriver (not included).
• Hand pump (not included) and inflation pin (included) required to inflate the soccer ball.
• Requires three “AAA” (LR03) alkaline batteries (not included) for operation.
• Please remove all parts from the package and identify them before assembly.
2 Side Tubes
Tube with Tapered End
and Regular End (Lower)
M5 x 28 mm Screw
BOTH SHOWN ACTUAL SIZE
Note: Tighten and loosen all screws with a Phillips Screwdriver.
Do not over-tighten the screws.
M5 Lock Nut
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2006 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA L5805a-0920
2
ASSEMBLY
ASSEMBLY
ASSEMBLY
CAUTION
This product contains small parts
in its unassembled state.
Adult assembly is required.
Rounded
Side
Tube with Tapered Ends
Tube with Tapered
End and Regular End
1
1
• Place a tube with tapered end and regular end on a flat surface.
• Fit a tube with tapered ends into the regular end, as shown.
Hint: The tube assembly should form this shape .
• Align the holes in the tubes.
• Fit a lock nut, rounded side out, into the hex hole on the inside of the
tube with tapered end and regular end.
• Insert a screw through the outside of the tube with tapered end and regular end.
• While holding the lock nut in place, tighten the screw.
Rounded
Side
Side Tube
Long End
Tapered
End
2
• Fit the long end of a side tube onto either tapered end of the assembly.
• Align the holes in the two tubes.
Hint: If the holes in the tubes do not align, remove the side tube and place it on the other end of the assembly.
• Fit a lock nut, rounded side out, into the hex hole in the inside of
the side tube.
• Insert a screw through the hole on the outside of the side tube.
• While holding the lock nut in place, tighten the screw.
Rounded
Side
Side Tube
Tapered
Long End
End
3
• Fit the long end of the other side tube onto the other tapered end of the assembly.
• Align the holes in the two tubes.
• Fit a lock nut, rounded side out, into the hex hole on the inside of the side tube.
• Insert a screw through the hole on the outside of the side tube.
• While holding the lock nut in place, tighten the screw.
3
Loading...
+ 5 hidden pages