Learning
™
Vacuum
Please keep this instruction
sheet for future reference, as it
contains important information.
Requires three “AA” batteries
(included).
Adult assembly is required.
Tool required for battery
replacement: Phillips
screwdriver (not included).
K7164
www.fisher-price.com
Assembly
Handle
• “Snap” the handle into the top of the vacuum.
Before Use
Battery Replacement
For best performance, we recommend replacing the batteries that
came with this toy with three, new “AA” (LR6) alkaline batteries.
• Loosen the screws in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screws with
a Phillips screwdriver. Do not over-tighten.
• When sounds or lights from this toy become faint or stop, it’s time
for an adult to change the batteries!
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
Please keep small parts such as
the plastic tab out of children’s reach.
Throw the plastic tab away.
Note: A plastic tab is attached to the toy for in-store demonstration
purposes. While the tab may have already been removed, check the
toy to be sure. If the plastic tab is still attached, pull and remove the
tab. Throw the plastic tab away.
FCC Statement
(United States Only)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and
harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to
operate the equipment.
used in accordance with the instructions, may cause
Battery Safety Information
1.5V x 3
“AA” (LR6)
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
Insert batteries as indicated inside the battery compartment.
•
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely. Do
not dispose of this product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Care
• Wipe this toy with a clean cloth dampened with a mild soap and
water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.