Page 1
K6673
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tools required for assembly: Phillips Screwdriver,
Hammer and Scrap Block of Wood (not included).
Age: 2-5 years
Weight limit: 55 lbs (25 kg).
www.fi sher-price.com
Page 2
Consumer Information
WARNING CAUTION
To avoid serious injury:
• Adult supervision is required.
• Never use near cars and other motor
vehicles, near streets, steps, sloped
driveways, hills, roadways, alleys, swimming
pool areas or other bodies of water.
• Always wear shoes or sneakers.
• Never allow more than one rider.
Note: Some parts shown are assembled
to both sides of the trike.
Handlebar Front
Handlebar Back
This product contains small parts
in its unassembled state.
Adult assembly is required.
IMPORTANT!
• Please save all packaging material until assembly is
complete to ensure that no parts are discarded.
• Please wipe each part with a clean, dry cloth
before assembly.
#8 x 2¼" Screw - 1
.354"
#8 x ¾" Screw - 6
.354" Cap Nut - 2*
ALL SHOWN ACTUAL SIZE
*We’ve included one extra .354" cap nut for your convenience.
Note: Tighten and loosen the screws with a Phillips screwdriver.
Do not over-tighten the screws.
Seat
Straight
Axle
2 Bushings
Frame
2 Rear Wheels
Front Wheel Assembly
2 Wheel Hubs
Fork
2 Fork Covers
4 Pedal Hubs
2 Wheel Caps
Part not shown: Label Sheet
2
Page 3
PUSH
Assembly
Seat
Frame
1
• Fit the seat onto the frame.
• Push rmly near the back end of the seat to "snap" it
into place.
Bushing
(Grooved Side Down)
Rear
Wheel
(Indented
Side Down)
Wheel Hub
(Flat Side Down)
Straight Axle Assembly
3
Bottom View
• Turn the frame upside down.
• Insert the straight axle assembly through the holes in
the rear of the frame.
Wheel
(Flat Side First)
Straight Axle
Bushing
(Smooth Side First)
Wheel Hub
(Pointed End First)
4
Straight
Axle
Straight
Axle
Cap Nut
2
• Place one end of the straight axle into the cap nut.
Tap the end of the straight axle with a hammer.
Make sure the cap nut is securely attached to the
straight axle.
• Slide a wheel hub,
• Slide a rear wheel,
straight axle.
• Slide a bushing,
straight axle.
grooved side down
at side down
indented side down
, onto the straight axle.
, onto the
, onto the
• Turn the assembly upright.
• Slide a bushing,
straight axle.
• Slide a wheel,
straight axle.
• Slide a wheel hub,
the straight axle.
3
smooth side rst
at side rst
pointed end rst
, onto the end of the
, onto the end of the
, onto the end of
Page 4
Assembly
Pedal Axle Tab
Pedal Hub
5
• Fit the cap nut on the end of the straight axle.
• Tap the cap nut with a hammer. Gently pull the rear
wheel to be sure the cap nut is securely attached
to the straight axle.
Hint: You may need the help of another adult to hold
the other end of the straight axle in place.
7
• Fit two pedal hubs onto the pedal axle tabs. Make sure
the tabs t into the slot in each pedal hub.
• While holding the pedal hubs on the pedal axle,
insert the pedal axle into the hole in the center of the
front wheel.
• Press the pedal hubs into the center of the front wheel
until they are ush with the surface of the front wheel.
• Repeat this procedure for the other two pedal hubs on
the other side of the front wheel assembly.
Front Wheel
Assembly
Pedal Hub
Fork Arms
Groove
Wheel Hub
6
• Fit the tabs on the wheel cap into the slots in the
wheel hub. Push to "snap" the wheel cap in place.
• Repeat this procedure to attach the other wheel cap
to the other wheel hub.
Wheel Cap
Fork Cover
Pedal Axle
8
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle ts into the groove at the
bottom of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x ¾" screws into the fork cover
and tighten.
• Repeat this procedure to attach the other fork cover
to the other fork arm.
4
Page 5
Label DecorationAssembly
REAR OF TRIKE
Fork Covers
Fork Post
9
• Insert the fork post up through the hole in the neck of
the frame. Make sure the fork is positioned so that the
fork covers face the rear wheels.
Fork Post
Handlebar Front
3
4
7
8
Right Side
1
2
6
Handlebar Back
¾" Screw
¾" Screw
2¼" Screw
10
• Fit the handlebar front to the fork post.
Hint: The handlebar front is designed to assemble to
the fork post one way.
• Fit the handlebar back to the fork post and handlebar
front. Hold them together rmly.
• First, insert the remaining #8 x ¾" screws through the
outer holes in the handlebar back and tighten.
• Then, insert the #8 x 2¼" screw through the center
hole in the handlebar back and tighten.
5
3
Left Side
• Wipe the vehicle with a clean, dry cloth to remove any
oils before applying labels.
• Apply labels exactly as shown in the illustrations. For
best results, avoid repositioning the label after it has
been applied.
• Starting at the center of a label rub rmly with a dry
cloth, and smooth towards the outer edges to remove
air bubbles.
5
Page 6
Care
CONSU
ASSISTANC
Consumer Information
• Periodically, check the plastic parts and if broken or
cracked, dispose of them properly.
• Periodically, check all fasteners regularly to be sure
they are tight. If the fasteners are not tight, tighten
them as necessary.
• To clean, use a mild soap and water solution and
a clean cloth. Rinse clean with water to remove
soap residue.
IMPORTANT! It is a good practice to start training
children very young regarding the importance of helmet
use. When children are older and riding bicycles and
faster vehicles, it is important that they use a helmet
each and every time they ride. For this reason, even
while riding a tricycle, it is a good idea to familiarize
your child with helmet use, so that it becomes a habit
for life. Choose a helmet that complies with requirements
of the applicable certifying agency for bicycle helmets.
MER
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
E
©2010 Viacom International Inc. Nickelodeon, Nick Jr., Dora the Explorer and all
related titles, logos and characters are trademarks of Viacom International, Inc.
PRINTED IN MEXICO K6673b-0920
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. Inc., unless otherwise indicated.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
Loading...