Fisher-Price K3309 Instruction Sheet

K3309

Please keep this instruction sheet for future reference,

as it contains important information.

Requires three "AAA" (LR03) alkaline

Adult assembly is required.

Tool needed for assembly: Phillips screwdriver (not included).

batteries (not included).

www.rescueheroes.com

for action, excitement and adventure!

ASSEMBLY

CAUTION

This toy contains small parts in its unassembled state.

Adult assembly is required.

Note: Tighten and loosen all

Screw (Inside)

Hole

Post

Blades

screws with a Phillips screwdriver.
Do not over-tighten screws.

• Fit the pegs on the bottom of
the helicopter through the holes
in the landing gear as shown.

• Insert the four screws through
the holes on the bottom of
the landing gear. Tighten
the screws.

• Fit the blades onto the post on
the top of the helicopter.

• Insert a Phillips screwdriver into
the hole in the top side of the
blades and tighten.

#4 x 3/8" Screw

Shown Actual Size

2

LABEL DECORATION

2

3

4

1

7

(6 on opposite side)

8
(9 on opposite side)

10

(11 on opposite side)

5

1

• Wash your hands before applying the labels.

• Make sure the areas where the labels will be applied are clean and dry. Wipe this
product with a clean, soft, dry cloth to remove any dust or oils.

• For best results, do not attempt to apply a label more than once.

• Apply the labels as shown in the illustrations.

3

BATTERY

INSTALLATION

BATTERY

SAFETY

INFORMATION

For best results, use only

alkaline batteries.

1.5V X 3

"AAA" (LR03)

SHOWN ACTUAL SIZE

BOTTOM VIEW

• Locate the battery compartment door
on the underside of the copter.

• Loosen the screw in the battery com
partment door with a Phillips screw
driver. Remove the battery
compartment door.

• Insert three, new "AAA" (LR03)
alkaline batteries.

• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.

• When lights or sounds become faint or
stop, it's time for an adult to change
the batteries!

Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.

©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

PRINTED IN CHINA K3309pr-0920

-

-

In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:

• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).

• Insert batteries as indicated inside the
battery compartment.

• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or
equivalent type as recommended.

• Do not charge non-rechargeable
batteries.

• Remove rechargeable batteries from
the product before charging.

• If removeable, rechargeable batteries
are used, they are only to be charged
under adult supervision.

4

TO THE RESCUE

Squeeze this button to

pop up the water blasters

Squeeze this button

to rotate the

helicopter blades

PUSH

WATER BLASTER

• Push the water missiles
into the water blasters
until they “click” in place.

• Push the button at the
back of the water blaster
to launch a missile.

Slide any Rescue Heroes®
figure into the connector

in the cockpit

Store back
packs here

• Press this button
for lights and
siren sounds.

Do not launch at people or animals or at point blank range.

Use only projectiles supplied with this toy.

5

(UNITED STATES ONLY)

This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:

- Reorient or relocate the receiving
antenna.

- Increase the separation between the
equipment and receiver.

- Consult the dealer or an experienced
radio/TV technician for help.

Note: Changes or modifications
not expressively approved by the
manufacturer responsible for compliance
could void the user’s authority to operate
the equipment.

CAREFCC STATEMENT

• Wipe the toy with a clean cloth
dampened with a mild soap and
water solution.

• Do not immerse the toy.

CONSUMER

INFORMATION

Visit us on-line at
www.service.fisher-price.co

Call Fisher-Price® Consumer Relations,
toll-free at

1-800-432-5437,

8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using
TTY/TDD equipment, please call
1-800-382-7470.

Or write to:

®

Fisher-Price
636 Girard Avenue
East Aurora

Consumer Relations

New York 14052

For countries outside the United States:

CANADA: Questions? 1-800-432-5437.

Mattel Canada Inc., 6155 Freemont Blvd., Missis­sauga, Ontario L5R 3W2; www.service.mattel.com.

GREAT BRITAIN: Mattel UK Ltd, Vanwall
Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303; www.service.mattel.com/uk

AUSTRALIA: Mattel Australia Pty. Ltd.,
58 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.

NEW ZEALAND: 16-18 William Pickering Drive,
Albany 1331, Auckland.

ASIA: Mattel East Asia Ltd, Room 1106,
South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China.

m

6