Fisher-Price K3116 Instruction Sheet

Troubleshooting
K3116
SYMPTOM SOLUTION
Engine drives slowly
Engine does not respond to the remote controller
Battery power in the engine may be weak. Replace all three batteries in the engine with fresh, alkaline batteries.
The wheels on the engine or attached cars may be dirty. Wipe them with a clean cloth.
Battery power in the remote controller may be weak. Replace all three batteries in the remote controller with fresh, alkaline batteries.
You may not have a clear path between the remote controller and the engine. This toy works best when there are no obstructions between the engine and the remote controller.
Bright sunlight or fluorescent lights may affect the range of the remote controller. Try dimming the room you are playing in.
The engine may have shut off. If you do not operate the remote controller for a few minutes, the engine shuts off automatically and the ready light turns off. Press the power button on the engine, and operate the remote controller to restart.
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help. Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment.
www.fisher-price.com
Visit www.fisher-price.com
to see the entire world of
GeoTrax® accessories!
Visit us on line at www.service.fisher-price.com.
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price® Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver
(not included).
Wipe the toy with a clean damp cloth. Do not immerse.
For other countries outside the United States:
Canada: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303. www.service.mattel.com/uk.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA ©2005 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. K3116pr-0920
Battery Information
SHOWN ACTUAL SIZE
We recommend the use of alkaline batteries
1.5V x 6
“AAA” (LR03)
for longer battery life
Battery Installation
Train Engine
• Locate the battery compartment on the back of the train engine.
• Loosen the screws in the battery compartment door with a Phillips screwdriver. Lift the battery compartment door and insert three “AAA” (LR03) alkaline batteries.
• Close the battery compartment door and tighten the screws with a Phillips screwdriver. Do not over-tighten.
IMPORTANT!
replacement more often than the batteries in the remote controller. For additional information, see the troubleshooting section.
Under normal use conditions, the batteries in the engine will require
Remote Controller
Locate the battery compartment on the side of the remote controller.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door and insert three “AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten.
Battery Safety Information
In exceptional circumstances, batteries injury or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the toy. Dispose of batteries safely. Do not dispose of product in a fire. The batteries inside inside may explode or leak.
may leak fluids that can cause a chemical burn
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
Your child is bound for
Your child is bound for
a world of adventure!
.
a world of adventure!
READY
LIGHT
Additional track sold separately and subject to availability.
The more you collect, the more fun it gets!
POWER
BUTTON
Multiple track packs used to create this configuration.
Each sold separately & subject to availability.
Use multiple
remote control
vehicles
at once!
Woo-
Woo-
Wooooo!
Wooooo!
Rhhhh!
Rhhhh!
Toot!
Toot!
Toot!
Toot!
All Aboard!
Hook the cars together and place them on the track. Make sure the engine is in front.
Hint:
We do not recommend using the engine on carpets. For best performance, use on the track provided or hard, flat surfaces
• Press the power button on top of the
engine. The ready light turns on.
• Hold the remote controller with the
stick facing you. Point the remote controller toward the engine and push the stick forward. The engine moves forward around the track.
• To stop the engine, pull the stick
backwards to the stop position.
Hints:
• If you do not operate the remote
controller for a few minutes, the engine shuts off and the ready light turns off. Press the engine power button, and operate the remote controller to restart.
This toy works best if you have a clear path between the remote controller and the engine. Point the remote controller at the engine. The maximum range of the remote controller is about 12 feet.
.
3-Position Remote Controller
3
2
1
1
OFF
2
FORWARD
3
FORWARD
(With Sound Effects)
WARNING
To prevent entanglement,
keep hair away from wheels.
Loading...