Page 1
J9000
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips screwdriver (not included).
Requires three, “AA” (LR6) alkaline batteries
for operation (not included).
www.fi sher-price.com
Page 2
Parts
Assembly
CAUTION
This product contains small parts in
its unassembled state. Adult assembly
is required.
2 Fences
Parts Not Shown:
3 Figures
Table
2 Chairs
Stroller
Play Center
Bed
Label Sheet
House
2 Posts
Pegs
Pegs
• Position the house so the bottom is facing you.
• Align the holes in a post with the matching pegs
on the bottom of the house as shown.
• Insert two screws through the post and into the
pegs. Tighten the screws with a Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to attach the other post.
• Set the house upright.
Post
Post
#6 x ½" (1.3 cm) Screw - 4
Shown Actual Size
Fastener
• Fasteners have been added to secure the figures
to the package. The fasteners are not a toy. Wiggle
and pull the fasteners to remove them. Throw
them away immediately.
2
Page 3
Let's Decorate the House!
21
23
24
17
20
1
19
6
5
3
7 10 18 4
2525
15
14
22
12
9
11
8
Proper label application will help to keep the labels looking their best!
• Make sure the areas where the labels will be applied are clean and dry. Wipe this product with a clean,
soft, dry cloth to remove any dust or oils.
• For best results, do not attempt to apply a label more than once.
• Apply the labels as shown in the illustration above.
2
13
3
Page 4
Battery Installation Battery Safety Information
Hint: We recommend using alkaline batteries for
longer battery life.
•
Locate the battery compartment on the bottom
the toy.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three, new
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
•
When sounds from this toy become faint or stop,
time for an adult to change the batteries!
•
Protect the environment by not disposing
of this product with household waste
(2002/96/EC). C
recycling advice and facilities (Europe only).
“AA” (LR6)
alkaline batteries.
heck your local authority
of
it’s
for
1.5V x 3
"AA" (LR6)
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery
compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not dispose
of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
•
Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
•
Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used,
are only to be charged under adult supervision.
they
Care
• Wipe the toy and figures with a clean cloth
dampened with a mild soap and water solution.
• This toy has no consumer serviceable parts. Do
not take this toy apart.
• Do not immerse the toy.
4
Page 5
Fun Sounds Around the House!
Press
Press
Press
Press to hear fun sound effects!
Press
Press
Press
• Locate the power switch on the bottom of the toy.
• Slide the switch to • on or
Hint: If your child is not actively playing with this toy, it turns off automatically
(sleep mode). Slide the power switch off and then back on again.
o
off.
Power Switch
5
Page 6
Attaching the Fences
Post
Clamp
• Push the post on the end of a fence onto the
clamp on the base of the toy.
Post
Clamp
FCC Statement
United States Only
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.
• Push the clamp on one end of a fence onto the
post on the base of the toy.
Consumer Information
Visit us on line at www.service.fisher-price.com
Call our Consumer Relations Department, toll-free
at 1-800-432-5437, 9 AM - 7 PM EST Monday
through Friday and 11 AM - 5 PM EST Saturday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.
Write to us at: Fisher-Price
®
Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc.,
6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;
www.service.mattel.com
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead
SL6 4UB. Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked
Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory
Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
PRINTED IN MEXICO J9000a-0920
©2006 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Loading...