Fisher-Price J5970 User Manual
www.fisher-price.com
J5970
Instructions
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required. Tool needed for assembly: Phillips screwdriver (not included).
Water or sand is needed to fill the base (not included).
IMPORTANT! Backboard height should be adjusted only by an adult.
Grow to Pro® Basketball
Parts
4
5
6
Hint: Some parts were placed inside the lower post for shipping.
Upper Post
Rim
Net Assembly
Ball Return
Backboard
Collar
Lower Post
Ball
Note: Label not shown.
#6 x 5/8" Screw - 4
SHOWN ACTUAL SIZE
Plug
Base
CAUTION
This product contains small parts
in its unassembled state.
Adult assembly is required.
2
Assembly
Ring Tab
Groove
Ring
Groove
Ring
Ta b
1
• Place the loops at the top of the net into the grooves
on the ring.
• Pull each loop through a ring tab, as shown.
Net Assembly
Hole
Hole
Rim
3
• While holding the ring assembly and rim together,
turn them over.
• Insert four screws into the holes in the rim, making sure
each hole in the rim is still aligned with each screw hole in
the net assembly.
• Partially tighten the screws with a Phillips screwdriver. Turn
the rim over to ensure that the net loops are still in the
grooves and through the ring tabs before completely tightening the screws. Do not over-tighten the screws.
Rectangular
Tabs
Rim
Hole
Hole
2
• Place the rim on a flat surface with the rectangular
tabs facing up.
• Locate the four screw holes on the underside of the
net assembly.
• Align the four screw holes on the underside of the net
assembly with the four holes in the rim.
• Place the net assembly onto the rim.
4
• Turn the rim upside down.
• Twist and insert the ends of the ball return into the slots in
the rim.
• Pull on the ball return to be sure all six ends are fastened
to the rim.
3
Loading...