Figures sold separately and subject to availability.
www.rescueheroes.com
for action, excitement and adventure!
Page 2
CONSUMER INFORMATION
• Please keep this instruction sheet
for future reference, as it contains
important information.
• Requires three "AAA" (LR03) alkaline
batteries (not included).
• Adult assembly is required.
• Tool needed for battery installation:
Phillips screwdriver (not included).
Visit us on line at
www.service.fisher-price.com
Call our Consumer Relations Department,
toll-free at 1-800-432-5437, 9 AM - 7 PM
EST Monday through Friday and 11 AM - 5 PM
EST Saturday. Hearing-impaired consumers
using TTY/TDD equipment, please call
1-800-382-7470. Write to us at:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada
• Make sure the areas where the labels
will be applied are clean and dry.
Wipe this product with a clean, soft,
dry cloth to remove any dust or oils.
• For best results, do not attempt to
apply a label more than once.
• Apply the labels as shown in
the illustrations.
2
3
5
1
1
4
5
Page 6
BATTERY
INSTALLATION
TOP VIEW
• Locate the battery compartment door
on the spoiler.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three, new "AAA" (LR03)
alkaline batteries.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• When lights or sounds become faint
or stop, it's time for an adult to
change the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
BATTERY SAFETY
INFORMATION
For best results, use only alkaline batteries.
1.5V x 3
"AAA" (LR03)
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from
the product before charging.
• If removeable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
6
Page 7
TO THE RESCUE
Press to Launch
Air Tank
Rescue Raft
Runner
Use only projectiles supplied with this toy.
Do not launch at people or animals or at
point blank range.
Air Tank
Track
• Fit the launcher into the hole in either
the spoiler or the rescue raft.
• Insert the air tank into the slot in the
launcher. Press the button to launch
the air tank.
• Place the runners on the sides of the
rescue raft onto the track under the
dune buggy. Push the raft under the
dune buggy until it “snaps” in place.
Press to Launch Raft
Rescue Raft
Press for Lights
and Sounds
• Press the button on the dune buggy to
launch the rescue raft.
• Press the spoiler button for lights and
siren sounds.
7
Page 8
CARE
FCC Statement
• Wipe the toy with a clean cloth
dampened with a mild soap and
water solution.
• Do not immerse the toy.
United States Only
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user's authority to operate the equipment.
8
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.