Page 1
3-in-1 Rockin‘ Gym
Please keep this instruction sheet
for future reference, as it contains
important information.
Requires three “AA” batteries
(included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver
(not included).
Floor Gym
1
J4185
Take-Along
2
Xylophone
Rockin’
3
Good Time
™
www.fisher-price.com
Page 2
Arch
Parts
2 Brackets
One-Time Assembly
CAUTION
This toy contains small parts
in its unassembled state.
Adult assembly is required.
Bracket
Bracket
Xylophone
2 Legs
2 Activity Toys
Arch
• Position the arch so the underside is facing you.
one end of the arch.
• Fit a bracket onto the end of the arch with the post,
the post fits into the opening in the bracket.
• Fit the other bracket to opposite end of the arch.
• Insert two screws into each bracket and tighten.
Post
Note the post at
making sure
#10 x 1” (2.5 cm) Screw - 4
Shown Actual Size
2
Page 3
Before First Time Use
Battery Safety Information
CAUTION
Please keep small parts such as the
plastic tabs out of children’s reach.
Throw the plastic tab away.
Note: A plastic tab is attached to the toy for in-store demonstration
purposes. Pull and remove the plastic tab from the back of the
xylophone. Throw the plastic tab away.
Battery Replacement
Battery
Compartment
Door
-
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
1.5V x 3
"AA" (LR6)
Shown Actual Size
+
Hanger
For best performance, we recommend replacing the batteries that
came with this toy with three, new alkaline “AA” (LR6) batteries.
• Locate the battery compartment on the back of the xylophone.
• Lift the hanger off the battery compartment door.
• Loosen the screws in the battery compartment door and remove
the battery compartment door.
• Insert three “AA” (LR6)
the battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
•
“Snap”
• When lights or sounds from this toy become faint or stop, it’s
the hanger back in place.
time for an adult to change the batteries!
alkaline
batteries, as indicated inside
3
Page 4
WARNING
To prevent entanglement
injury, never place the
gym in a crib or playpen.
Never add strings,
ties or other products
to the gym.
Building the Floor Gym
1
1
• Insert and
“snap” a
leg into
each end of
the arch.
• Pull up on the
arch to be
sure it
is secure.
2
1
• Press the
button on
the neck of
the xylophone
and lift.
• Lift both
hangers and
rotate down.
Legs
Arch
PRESS
3
1
• While pressing
the button on
the neck of
the xylophone
insert and
“snap” it
into the
opening in
the arch.
1
4
• Attach the
activity toys
to the
hangers
under the
xylophone.
Xylophone
PRESS
Neck
Hanger
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. PRINTED IN CHINA
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. J4185pr-0920
4
Activity Toys
Page 5
Convert to a Rocker
PRESS
1
1
• Remove the
activity toys from
the hangers.
• Press the button
on the neck of
the xylophone
and pull to
remove it from
the arch.
1
2
• “Snap”
the hangers
back onto the
back of the
xylophone.
PRESS
1
3
• Press the button
on the side of a
leg and pull to
remove the leg.
• Repeat this
procedure to
remove the
other leg.
1
4
•
Fit the legs
together,
as shown.
PRESS
5
Page 6
5
Convert Back to a Floor Gym
1
1
1
• Position the arch
above the legs.
• Press and “snap”
one end of the
arch to the
legs .
• Press and “snap”
the other end of
the arch to
the legs .
1
6
• Press down
firmly in the
center of the
arch to
it to the legs.
Hint: This may require some force.
• Pull up on the
arch to be sure
it is secure to
the legs.
7
“snap”
1
PRESS
• Lower the
support underneath the
xylophone.
• Press the button
on the neck on
the xylophone
and remove it
from the arch.
1
2
•
First, press the
leg firmly to
the arch, as
shown
•
Then, press
the button on
the end of the
leg and lift
the arch to
separate it
•
Repeat this
procedure to
separate the
other leg from
the arch.
.
.
• While pressing
the button on
the neck of
the xylophone,
insert and
“snap” it into
the opening
in the top of
the arch.
1
8
• Lift and fit
the support
to the
xylophone.
PRESS
1
3
• Grasp the arch
near the center
and pull firmly
to separate it
from the center
of the legs.
1
4
• Now, follow the
instructions on
page 4 to build
the floor gym.
6
Page 7
Take Along Xylophone
3 Ways to Play!
Volume Switch
• Slide the volume switch on back of the xylophone to high
or low , for your child’s comfort.
• Press the button on the neck of the xylophone and pull to
remove it from the top or bottom of the arch.
• “Snap” both hangers back onto the back of the xylophone.
Mode Switch
• Slide the mode switch to I. Baby can press the xylophone keys
or bat at the hanging toys for about five minutes of music.
• Slide the mode switch to
a song.” Each time you press, you hear part of a song. Press
again to hear more.
• Slide the mode switch to
xylophone keys to hear individual notes.
• When you are finished playing with this toy, slide the mode
switch off
.
II.
Press the xylophone keys to “build
III.
Rock the toy for music or press the
7
Page 8
Care
Consumer Information
• Wipe this toy with a clean cloth dampened with a mild soap and
water solution. Do not immerse this toy.
• The xylophone has no consumer serviceable parts. Do not take the
xylophone apart.
FCC Note Statement (United States Only)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communica-tions. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
Visit us on line at www.service.fisher-price.com.
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price
®
Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China.
8
Loading...