Page 1
ROCK CLIMBER
Phillips screwdriver (not included).
J0208
™
CAR CRUSHER
J0209
™
SAND BLASTER
J0210
Each sold separately and subject to availability.
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "AA" batteries (included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).
™
MUD EATER
™
™
J0211
www.fisher-price.com
Page 2
Remove Plastic Tab
CAUTION
Please keep small parts such
as plastic tabs out of children’s
reach. Throw the plastic tab away.
• A plastic tab was attached to this toy
for in-store demonstration purposes.
While the tab may have already
been removed, check the bottom of
the toy to be sure. If the plastic tab
is still attached, pull and remove the
tab from the toy. Throw the plastic
tab away.
Reset Electronics
• After removing the plastic tab,
you will need to reset the electronics
on the toy. Slide the on /off switch on
the bottom of the toy off
back on
.
and then
2
Page 3
Battery Replacement
For best performance, we recommend
replacing the batteries that came with
this toy with three, new alkaline “AA”
(LR6) batteries.
• Locate the battery compartment door
on the bottom of the toy.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Remove the exhausted batteries and
throw them away.
• Insert three, new "AA" (LR6)
alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
• When sounds or motions become
faint or stop, it’s time for an adult to
change the batteries!
1.5V x 3
"AA" (LR6)
Shown Actual Size
Battery Safety Information
In exceptional circumstances, batteries
may
leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries
from the
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
product before charging.
product. Dispose of
3
Page 4
Shake It, Then Race It!
CAUTION
To prevent entanglement,
keep hair away from wheels.
1
• Locate the on/off switch on the
bottom of the
• Slide the switch on .
vehicle.
2
• Lift the vehicle and shake it to start
the "engine" and the lights.
3
™
• Set the vehicle down and off it goes!
The more you shake your vehicle,
the longer it goes!
• When you're finished, slide the
on/off switch
off .
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
PRINTED IN CHINA J0208pr-0920
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
4
Page 5
Care
FCC Note (United States Only)
• Wipe this toy with a clean cloth
dampened with a mild soap and
water solution. Do not immerse
this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications
not expressly approved by the
manufacturer responsible for
compliance could void the user’s
authority to operate the equipment.
5
Page 6
Consumer Information
Visit us on line at www.service.fisher-price.com.
®
Call Fisher-Price
Consumer Relations, toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-
Write to us at: Fisher-Price
7470.
®
Consumer Relations, 636 Girard Avenue, East Aurora,
New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN:
www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303.
6
Loading...